INSTALLATION
Continued
8.Install remote receiver into receiver bracket using pads and push button clips provided with receiver (see Figure 20).
9.Connect wires to control valve at the TPTH and TH locations as shown in Figure 21. Note: Make sure excess wire does not interfere with burner or pilot.
10.If heater was removed from fireplace before installation of remote accessory, see Installing Heater Base Assembly on page 13 to reinstall heater into fireplace. Test gas connection for leaks (see Checking Gas Connections, pages 15 and 16).
11.If logs were removed from heater for install remote accessory, replace logs (see Installing Logs, pages 18 and 19).
Battery
Clip
Bracket | Pad | Terminal |
Push Button |
| |
| Wires | |
Clips |
| |
|
| |
Figure 20 - Installing Remote Receiver |
White Wire
From Receiver
Control
Valve
Red Wire From
Receiver
Figure 21 - Connecting Wires
Installing Batteries for Remote Receiver and Hand Held Remote Control Two
Installing
1.Locate back of receiver behind receiver bracket mounted on base assembly.
2.Locate the battery clip mounted on the back of the receiver (see Figure 20).
3.Slide a
4.Attach the terminal wires to the battery.
Installing
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery. Place battery into the battery housing.
Terminal | Battery Cover |
| |
Wires |
|
|
|
| Remote |
|
|
| Control |
| Battery | Unit | |
|
| ||
Battery |
|
| |
| Housing |
| |
|
|
| |
Figure 22 - Installing Battery in Hand- | |||
Held Remote Control Unit (CGHRCB | |||
| Series) |
| |
|
| Remote | |
| Terminal | Control Unit | |
|
|
| |
Wires |
|
| |
|
|
| |
Battery |
|
|
|
|
|
| Battery |
Battery |
|
| Cover |
|
|
| |
Housing |
|
|
|
Figure 23 - Installing Battery in Hand- | |||
Held Remote Control Unit (CGHRCTB | |||
| Series) |
|
www.desatech.com | 17 |