Samsung AR12HSFSSWKNTV, AR24HSFSSWKNTV, AR30HSFSSWKNTV manual Drain hose installation, English-44

Installing and connecting the drain hose of the indoor unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate. When passing the drain hose through the 65 mm hole drilled in the wall, check the followings:

Wall

Indoor unit

Drain hose

The drain hose must NOT	The end of the drain hose	The drain hose must not
slant upwards.	must NOT be placed under	be bent.
	water.

		After completing the
		installation of the drain
		hose, pour water into
		the drain pan to check
5cm		whether the hose is well
less	Ditch	drained.

Keep a clearance of at least		Do not place the end of the
5 cm between the end of the		drain hose in a hollow.
drain hose and the ground.
	1) Correct connection		2) Incorrect connection

Drain hose Pipe

Drain hose Pipe

• Don’t tie drain hose to the assembly pipe which may lead to water leakage.

Drain hose installation

1.If necessary, connect the 2 meter extension drain hose to the drain hose.

2.If you use the extension drain hose, insulate the inside of the extension drain hose with a shield.

3.Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose tightly with a clamp.

• If you do not use the other drain hose hole,

block it with a rubber stopper.

4.When extending the Drain Hose, hold the end of Drain Hose and Extended Hose, rotate and insert the drain hose into Extended hose for 40~45 mm. Make sure the two hoses are firmly connected, there is no water leakage.

Drain hose hole

5.Connect the Drain Hose after using Foam Insulation to wrap the Extended Hose. Then, Use vinyl tape to wrap the each side of connection by 20 mm .

English-44

A3050 TV_IB&IM_DB68-04043A-01_EN.indd 44

2014/8/15 15:44:38