Quadra-Fire CB1200 owner manual Cleaning the Glass Frequency As needed, Cleaning the Hopper

Page 30

CB 1200 Pellet Stove

R

10.Cleaning the Glass

•Frequency: As needed

•By: Homeowner

•Task:

a.Appliance must be completely cool before cleaning glass.

b.Use a damp paper towel or any non-abrasive glass cleaner. Wipe off with dry towel.

CAUTION

Handle glass assembly with care.

When cleaning glass:

• Avoid striking, scratching or slamming glass.

• Do NOT clean glass when hot.

•Do NOT use abrasive cleaners.

•Use a hard water deposit glass cleaner on white film.

•Refer to maintenance instructions.

WARNING

Handle glass with care.

• Inspect the gasket to ensure it is undamaged.

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass assembly removed.

•Do NOT operate with glass cracked, broken or scratched.

11.Cleaning the Hopper

•Frequency: Monthly or after burning 1 ton of fuel

•By: Homeowner

•Task:

After burning approximately 1 ton of fuel you will need to clean the hopper to prevent sawdust build-up. A combi- nation of sawdust and pellets on the auger reduces the amount of fuel supply to the firepot. This can result in nuisance shutdowns and mis-starts.

a.The appliance must be in complete shutdown. Allow the appliance to completely cool down and then unplug it.

bEmpty the hopper of any remaining pellets.

c.Vacuum the hopper and feed tube.

12.Cleaning Exhaust Blower - Requires No Lubrication

•Frequency: Yearly or as needed

•By: Quality Service Technician/Homeowner

•Task:

a.Locate the blower on the left side of the appliance by opening both the left side curtain and the left pedestal access door. To clean the impeller it is easier to access through the right side curtain.

13.Door Latch Inspection

•Frequency: Periodically

•By: Homeowner

•Task:

The same latch is used on both the front door and the ash drawer. To adjust, open the latch and pivot the holding rod out. Loosen the jam nut on the rod. With a Phillips head screw driver, turn the rod clockwise to tighten. The latch handle should snap securely in place when adjusted properly. After adjusting the latch, be sure to tighten the jam nut on the rod to hold the adjustment.

14.Cleaning Convection Blower - Requires No Lubrication

•Frequency: Yearly or as needed

•By: Qualified Service Technician

•Task: Contact your local dealer.

15.Soot and Fly Ash: Formation & Need for Removal in Exhaust Venting System.

•Frequency: Yearly or as needed

•By: Qualified Service Technician/Homeowner

•Task:

The products of combustion will contain small particles of fly ash. The fly ash will collect in the exhaust vent- ing system and restrict the flow of the flue gases. At start-up if there is incomplete combustion, or if there is a shutdown or incorrect operation of the appliance it will lead to some soot formation. This will collect in the exhaust venting system.

The venting system may need to be cleaned at least once a year or more often depending upon the quality of your fuel or if there is a lot of horizontal pipe sec- tions. Ash will build up more quickly in the horizontal sections.

16.Cleaning the Top Vent Adapter

a.The appliance must be in complete shutdown and the exhaust blower should be off. Allow the appliance to completely cool down.

b.Open the clean-out cover. See Figure 28.1.

c.Sweep out any ash build-up.

NOTE: There are heavy duty vacuum cleaners specifiically designed for solid fuel appliance cleaning.

Clean Out

Cover

Figure 28.1

Page 30

7014-082B

September 21, 2006

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Classic BAY 1200 Pellet Stove Testing Lab & Report Number Serial Number Model Mfg Date CB 1200 Pellet StoveBehind left side curtain on outside of hopper wall Table of Contents Listing and Code Approvals Getting Started Design, Installation & Location ConsiderationsFire Safety Appliance LocationCB 1200 Pellet Stove Tools And Supplies Needed Measuring StandardsInspect Appliance & Components and Pre-Use Check List Dimensions and Clearances Appliance DimensionsCB 1200 Pellet Stove Clearances to Combustibles UL and ULC Exception for Horizontal Installations CB 1200 Pellet Stove Hearth Pad Requirements UL and ULCHearth Pad Requirements Vent Information CB 1200 Pellet Stove Equivalent Feet of Pipe Pipe Selection ChartLevel of this installation. See Figure Example of 3 Elbow-Rear Vent Termination Calculaton5Venting Systems AlcoveStraight Out DegreeCB 1200 Pellet Stove Through The Wall CB 1200 Pellet Stove Vertical Through The Wall & VerticalMasonry Alternate MasonryMobile Home Rear Installation Floor Installation Appliance Set-UpOutside Air Kit Instructions CB 1200 Pellet Stove Top Vent Adapter Installation Rear Vent and Rear Vent to Top Vent Adapter InstallationInstalling the Top Vent Adapter CB 1200 Pellet Stove Brick Set Installation Brick Clip InstallationLeft Twig Right Twig Installing Logo Nickel OnlyCharred Areas in the Back Front Log Holes. See FigureTo install door Door InstallationCB 1200 Pellet Stove Thermostat Installation To adjust latchesOperating Instructions Fuel Size And Material General Operating InformationFuel Adjustment Rod Feed Rate Adjustment InstructionsStarting Your First Fire Frequently Asked Questions CB 1200 Pellet Stove Ignition CyclesTroubleshooting SymptomPossible Cause Corrective Action Page Page Maintaining & Servicing Your Appliance Ash Removal from Firebox Cont’d Cleaning Heat Exchanger ChambersCleaning Beneath Heat Exchanger Disposal of Ashes Frequency As neededCleaning Exhaust Blower Requires No Lubrication Cleaning the Glass Frequency As neededCleaning the Hopper Cleaning Convection Blower Requires No LubricationCB 1200 Pellet Stove High Ash Fuel Content Maintenance Convection Blower ReplacementExhaust Blower Replacement Remove existing blower Install new blowerRe-install blower to blower housing Replacing Center Glass Replacing Side GlassScrews Reference Materials CB 200 Pellet StoveComponent Function & Location Snap Disc #1 Convection Blower 145F Vacuum SwitchWiring Harness See .1 below Snap Disc #2 Thermostat Override 200FCB 1200 Pellet Stove Component Locations CB 1200 Pellet Stove Exploded Views Glass Size Center 13-7/8 wide x 11 highGlass Size Sides Nbr Description CB 1200 Pellet Stove CB 1200 Pellet Stove Service Parts and Accessories Item # Parts Alphabetical OrderItem # Service Parts Alphabetical Order AccessoriesAppliance CB 1200 Pellet Stove Service And Maintenance Log Date of Service Performed By Description of ServiceLifetime Warranty CB 1200 Pellet Stove Warranty PolicyContact Information Telephone

CB1200 specifications

The Quadra-Fire CB1200 is a highly efficient and versatile wood-burning stove that stands out in the market for its innovative features and robust performance. With a focus on both functionality and aesthetics, the CB1200 aims to provide a comfortable, efficient heating solution while enhancing the beauty of any living space.

One of the main features of the Quadra-Fire CB1200 is its powerful heating capability. It boasts a maximum heat output of up to 80,000 BTUs, making it suitable for heating large areas within homes and cabins. The unit can efficiently heat spaces up to 2,500 square feet, offering reliable warmth even in the coldest climates. This impressive output is complemented by an extended burn time, allowing for longer periods between refueling, which adds convenience for users.

The CB1200 comes equipped with Quadra-Fire's renowned Advanced Combustion Technology. This cutting-edge system improves the efficiency of the fire by maximizing the combustion of gases and particles, leading to a cleaner burn with reduced emissions. This not only enhances the stove's overall performance but also provides a more environmentally friendly heating solution.

Another notable characteristic of the CB1200 is its user-friendly design. The large, glass door provides an excellent view of the fire, creating a warm and inviting ambiance while ensuring easy monitoring of fuel levels. The stove features a convenient ash pan for effortless cleanup, and the adjustable airflow control allows users to customize the burn intensity to suit their heating needs.

In addition to its performance features, the CB1200 is designed with durability in mind. Constructed from high-quality materials, it is built to withstand the rigors of regular use. The unit also offers various finishing options, enabling homeowners to select a style that complements their décor.

The Quadra-Fire CB1200 combines efficiency, beauty, and convenience, making it an exemplary choice for anyone seeking a wood-burning stove. With its impressive heating capabilities, advanced combustion technology, and user-friendly features, the CB1200 is designed to provide lasting comfort and satisfaction for its users, making it a worthwhile investment for any home.
Top Page Image Contents