Quadra-Fire CUMBGAP-MBK, CUMPGAP-PMH warranty Cumberland Gap Wood Stove Mobile Home Installation

Page 23

R

Cumberland Gap Wood Stove

6 Mobile Home Installation

You must use a Quadra-Fire Outside Air Kit Part 831-1780 for installation in a mobile home.

1.An outside air inlet must be provided for combustion See page 17 for installation information.

2.Appliance must be secured to the mobile home structure by bolting the pedestal through hearth pad and into floor.

3.Appliance must be grounded with #8 solid copper grounding wire or equivalent and terminated at each end with N.E.C. approved grounding device.

4.Appliance must be installed with an approved UL103 HT ventilated chimney connector, UL103 HT chimney, and terminal cap with spark arrestor. Never use a single wall connector (stove pipe) in a mobile home installation. Use only double-wall connector pipe, Dura-Vent DVL, Selkirk metalbestos DS or Security DL double-wall connector or any listed double-wall connector pipe.

5.In Canada, this appliance must be connected to a 6 inch (152mm) factory-built chimney conforming to CAN/ULC-

629M, STANDARD FOR FACTORY BUILT CHIMNEYS.

6.Follow the chimney and chimney connector manufacturer’s instructions when installing the flue system for use in a mobile home.

7.Maintain clearance to combustibles.

8.Floor protection requirements must be followed precisely.

9.Use silicone to create an effective vapor barrier at the location where the chimney or other component penetrates to the exterior of the structure.

NOTE: Offsets from the vertical, not exceeding 45°, are allowed per Section 905(a) of the Uniform Mechanical Code (UMC). Offsets greater than 45° are considered horizontal and are also allowed, providing the horizontal run does not exceed 75% of the vertical height of the vent. Construction, clearance and termination must be in compliance with the UMC Table 9C. This installation must also comply with NFPA 211.

NOTE: Top sections of chimney must be removable to allow maximum clearance of 13.5 feet (411cm) from ground level for transportation purposes.

10.Burn wood only. Other types of fuels may generate poisonous gases (e.g., carbon monoxide).

11.If unit burns poorly while an exhaust blower is on in home, (i.e., range hood), increase combustion air.

12.Installation shall be in accordance with the Manufacturers Home & Safety Standard (HUD) CFR 3280, Part 24.

Spark Arrestor Cap

Storm Collar

Roof Flashing

Joist Shield/Firestop

Listed Chimney

Outside Air Kit

Connector

Floor Protector

Outside Air Floor Vent

Figure 23.1

CAUTION

THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/ROOF MUST BE MAIN- TAINED

Do NOT cut through:

Floor joist, wall, studs or ceiling trusses.

Any supporting material that would affect the structural integrity.

WARNING

Asphyxiation Risk.

NEVER INSTALL IN A SLEEPING ROOM.

Consumes oxygen in the room.

November 5, 2010

7006-188G

Page 23

Image 23
Contents Non-Catalytic, Front/Side Load, Wood Heater Cumberland GapModel Name Testing LabCumberland Gap Wood Stove Serial NumberTable of Contents Mobile Home Approved Cumberland Gap Wood Stove Listing and Code ApprovalsAppliance Certification BTU & Efficiency SpecificationsAsphyxiation Risk Fire SafetyDesign, Installation & Location Considerations Getting Started Cumberland Gap Wood StoveWindward Negative PressureInspect Appliance & Components and Pre-Burn Check List Flue Draft ConsiderationsVenting Systems Tools And Supplies NeededStove system with masonry chimney consists of Figure Typical Stove SystemsAppliance Dimensions Dimensions and ClearancesDouble Wall-USA Clearances To Combustibles UL And ULCSingle Wall-USA Hearth Protection Requirements Installation ConsiderationsUSA Required Canada Recommended Calculating Alternate Floor Protection MaterialCompleted View Reversible Flue Collar and Horizontal Flue Heat ShieldSlanted corner Straight end to the back Baffle DiverterBaffle Diverter Fire RiskCut Ends Hand Bend #1 Hand bend #2 Straight End Baffle Diverter Is shipped Inside fireboxCumberland Gap Wood Stove Instructions To Unlock Side Fuel Door Leg Leveling SystemSide Fuel-Loading-Door Locking Mechanism Outside Air Kit Installation Installation Of Optional Blower Chimney Systems Cumberland Gap Wood Stove Chimney RequirementsVenting Components Instructions ComponentsAir Clearances Chimney Height / Rise and Run Masonry Chimney LinerMasonry Chimney Liner Contd Installing Chimney ComponentsRule Chimney Termination Requirements629M, Standard for Factory Built Chimneys Cumberland Gap Wood Stove Mobile Home InstallationNeeds to move smoothly Adjusting The Blower Speed ControlCumberland Gap Wood Stove Appliance Set-Up Door Handle AssembliesProcessed Solid Fuel Fire Logs Cumberland Gap Wood Stove Operating InstructionsOver-Firing Your Appliance Wood Selection and Storage Hardwood vs SoftwoodStoring Wood Burning ProcessMoisture Seasoned WoodStart-Up Air System Air ControlsCombustible/Non-Combustible Materials Final StageMedium-Low Burn Rate* 10,000 to 15,000 BTU/hr Heat Output Settings Building a FireBurn Rates High Burn Rate Maximum Heat* 30,000+ BTU/hrOpacity Smoke Optional Blower Operating InstructionsClear Space Frequently Asked QuestionsIncorrect Positions Correct Baffle & Blanket PlacementInjury Risk General MaintenanceCreosote Chimney Cleaning Ash Removal System ARS Operating and CleaningDisposal of Ashes Glass Cleaning Frequency As desiredCleaning Plated Surfaces When cleaning glassFire Risk Injury Risk Inspect Firebrick & Replacement InstructionsGlass Replacement Appliance Inspection RoutineBaffle Removal & Installation Monthly Quick Reference Maintenance GuideStart Fire Problems Possible Cause Solution Cumberland Gap Wood Stove Troubleshooting GuideService Parts At Depot Service PartsStocked #20 Brick Set Stocked at DepotCumberland Gap Warranty Policy November 5 7006-188G Contact Information

CUMBGAP-MBK, CUMPGAP-PMH specifications

The Quadra-Fire CUMPGAP-PMH and CUMBGAP-MBK are established models in the realm of high-efficiency wood stoves, combining modern technology with traditional heating methods to provide an effective and environmentally friendly heating solution.

One of the standout features of the CUMPGAP-PMH and CUMBGAP-MBK models is their impressive heating efficiency. Both stoves exceed industry standards, ensuring that more heat is produced from less fuel, which not only helps in saving on heating costs but also reduces the environmental impact. Their efficient combustion technology means that these stoves produce minimal emissions, making them a responsible choice for eco-conscious consumers.

The construction of these stoves is designed with durability and robustness in mind. Made from high-quality materials, they assure longevity and reliability, which are crucial elements in heating appliances. The intelligently engineered airflow dynamics facilitate efficient burning, allowing these models to maintain optimal performance under various conditions.

Another significant feature of both models is the incorporation of advanced catalytic combustors. These catalysts improve the combustion process, resulting in cleaner burning and enhancing overall efficiency. The catalytic technology functions by allowing smoke and gases to pass through the catalyst, where they undergo additional burning before being released into the atmosphere. This process not only maximizes heat generation but also significantly lowers the emissions of harmful pollutants.

User convenience is also a top priority with these wood stoves. They feature large ash pans and simple loading mechanisms, making it easy to maintain and use them regularly. Their stylish design allows them to fit seamlessly into any home décor, and with variable heating capacities, they can effectively warm spaces of different sizes.

Safety features are another vital characteristic of the CUMPGAP-PMH and CUMBGAP-MBK models. With built-in heat shields and thermal protection, they provide peace of mind to homeowners while promoting safer operation. Additionally, they comply with various safety and efficiency standards set by regulatory bodies.

In conclusion, the Quadra-Fire CUMPGAP-PMH and CUMBGAP-MBK models stand out for their efficiency, design, advanced combustion technology, and safety features. They offer a modern solution to traditional wood heating, ensuring warmth and comfort while taking care of the environment. These stoves represent the perfect synergy of innovation and effectiveness in home heating solutions.