Quadra-Fire CUMPGAP-PMH Cumberland Gap Wood Stove Listing and Code Approvals, Glass Specifications

Page 4

R

Cumberland Gap Wood Stove

1 Listing and Code Approvals

A. Appliance Certification

Model:

Cumberland Gap

Laboratory:

OMNI Test Laboratories, Inc.

Report No & Date:

061-S-55-2

Type:

Listed Room Heater, Solid Fuel Type

Standard:

UL1482, UL737, ULC S627-00

 

and (UM) 84-HUD, Mobile Home

 

Approved.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the UL1482, UL737, (UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S627-00 and CAN/CSA-B365 Installation Codes in Canada.

D. BTU & Efficiency Specifications

EPA Certified:

3.44 grams per hour

Efficiency:

79.3%

BTU Output:

11,200 to 44,300

Heating Capacity:

1,940 to 3,350 sq ft

 

depending on climate zone

Vent Size:

6 inches

Firebox Size:

2.39 cubic feet

Max Wood Length:

20 inches

Fuel:

Cord Wood

Shipping Weight:

462 lbs

The Quadra-Fire Yosemite Wood Stove meets the U.S. Environmental Protection Agency’s 1990 particulate emis- sion standards.

B. Mobile Home Approved

This appliance is approved for mobile home installa- tions when not installed in a sleeping room and when an outside combustion air inlet is provided.

The structural integrity of the mobile home floor, ceil- ing, and walls must be maintained.

The appliance must be properly grounded to the frame of the mobile home with #8 copper ground wire, and use only listed double-wall connector pipe.

Outside Air Kit, part 831-1780 must be installed in a mobile home installation.

C. Glass Specifications

This stove is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

Installation and use of any damaged appliance.

Modification of the appliance.

Installation other than as instructed by Hearth & Home Technologies.

Installation and/or use of any component part not approved by Hearth & Home Technologies.

Operating appliance without fully assembling all components.

Operating appliance without legs attached (if supplied with unit).

Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

Page 4

7006-188G

November 5, 2010

Image 4
Contents Cumberland Gap Non-Catalytic, Front/Side Load, Wood HeaterTesting Lab Cumberland Gap Wood StoveSerial Number Model NameTable of Contents Cumberland Gap Wood Stove Listing and Code Approvals Appliance CertificationBTU & Efficiency Specifications Mobile Home ApprovedFire Safety Design, Installation & Location ConsiderationsGetting Started Cumberland Gap Wood Stove Asphyxiation RiskNegative Pressure WindwardFlue Draft Considerations Venting SystemsTools And Supplies Needed Inspect Appliance & Components and Pre-Burn Check ListTypical Stove Systems Stove system with masonry chimney consists of FigureDimensions and Clearances Appliance DimensionsSingle Wall-USA Clearances To Combustibles UL And ULCDouble Wall-USA Installation Considerations Hearth Protection RequirementsCalculating Alternate Floor Protection Material USA Required Canada RecommendedReversible Flue Collar and Horizontal Flue Heat Shield Completed ViewBaffle Diverter Baffle DiverterFire Risk Slanted corner Straight end to the backCumberland Gap Wood Stove Baffle Diverter Is shipped Inside fireboxCut Ends Hand Bend #1 Hand bend #2 Straight End Side Fuel-Loading-Door Locking Mechanism Leg Leveling SystemInstructions To Unlock Side Fuel Door Outside Air Kit Installation Installation Of Optional Blower Venting Components Cumberland Gap Wood Stove Chimney RequirementsChimney Systems Air Clearances ComponentsInstructions Masonry Chimney Liner Chimney Height / Rise and RunInstalling Chimney Components Masonry Chimney Liner ContdChimney Termination Requirements RuleCumberland Gap Wood Stove Mobile Home Installation 629M, Standard for Factory Built ChimneysAdjusting The Blower Speed Control Cumberland Gap Wood Stove Appliance Set-UpDoor Handle Assemblies Needs to move smoothlyCumberland Gap Wood Stove Operating Instructions Over-Firing Your Appliance Wood Selection and StorageHardwood vs Softwood Processed Solid Fuel Fire LogsBurning Process MoistureSeasoned Wood Storing WoodAir Controls Combustible/Non-Combustible MaterialsFinal Stage Start-Up Air SystemHeat Output Settings Building a Fire Burn RatesHigh Burn Rate Maximum Heat* 30,000+ BTU/hr Medium-Low Burn Rate* 10,000 to 15,000 BTU/hrOptional Blower Operating Instructions Opacity SmokeFrequently Asked Questions Clear SpaceCorrect Baffle & Blanket Placement Incorrect PositionsGeneral Maintenance Creosote Chimney CleaningAsh Removal System ARS Operating and Cleaning Injury RiskGlass Cleaning Frequency As desired Cleaning Plated SurfacesWhen cleaning glass Disposal of AshesInspect Firebrick & Replacement Instructions Glass ReplacementAppliance Inspection Routine Fire Risk Injury RiskBaffle Removal & Installation Quick Reference Maintenance Guide MonthlyCumberland Gap Wood Stove Troubleshooting Guide Start Fire Problems Possible Cause SolutionService Parts Stocked Service PartsAt Depot Stocked at Depot #20 Brick SetCumberland Gap Warranty Policy November 5 7006-188G Contact Information

CUMBGAP-MBK, CUMPGAP-PMH specifications

The Quadra-Fire CUMPGAP-PMH and CUMBGAP-MBK are established models in the realm of high-efficiency wood stoves, combining modern technology with traditional heating methods to provide an effective and environmentally friendly heating solution.

One of the standout features of the CUMPGAP-PMH and CUMBGAP-MBK models is their impressive heating efficiency. Both stoves exceed industry standards, ensuring that more heat is produced from less fuel, which not only helps in saving on heating costs but also reduces the environmental impact. Their efficient combustion technology means that these stoves produce minimal emissions, making them a responsible choice for eco-conscious consumers.

The construction of these stoves is designed with durability and robustness in mind. Made from high-quality materials, they assure longevity and reliability, which are crucial elements in heating appliances. The intelligently engineered airflow dynamics facilitate efficient burning, allowing these models to maintain optimal performance under various conditions.

Another significant feature of both models is the incorporation of advanced catalytic combustors. These catalysts improve the combustion process, resulting in cleaner burning and enhancing overall efficiency. The catalytic technology functions by allowing smoke and gases to pass through the catalyst, where they undergo additional burning before being released into the atmosphere. This process not only maximizes heat generation but also significantly lowers the emissions of harmful pollutants.

User convenience is also a top priority with these wood stoves. They feature large ash pans and simple loading mechanisms, making it easy to maintain and use them regularly. Their stylish design allows them to fit seamlessly into any home décor, and with variable heating capacities, they can effectively warm spaces of different sizes.

Safety features are another vital characteristic of the CUMPGAP-PMH and CUMBGAP-MBK models. With built-in heat shields and thermal protection, they provide peace of mind to homeowners while promoting safer operation. Additionally, they comply with various safety and efficiency standards set by regulatory bodies.

In conclusion, the Quadra-Fire CUMPGAP-PMH and CUMBGAP-MBK models stand out for their efficiency, design, advanced combustion technology, and safety features. They offer a modern solution to traditional wood heating, ensuring warmth and comfort while taking care of the environment. These stoves represent the perfect synergy of innovation and effectiveness in home heating solutions.