LOG PLACEMENT
Before you begin — This unit is supplied with four ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
WARNING
The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.
Top Left
Log #4
Left
Bottom
Log #2
Left Log
Support
Bracket
REMOTE | CONTROL |
|
PILOT
Right
Top Log
#5
Right
Bottom
Log #3
Back Log
#1
Rear Log
Support
Bracket
Right Log
Support
Bracket
OFF
INSTALLING LOGS ON GRATE (See Figure 17)
1.Install back log (#1) on rear log support bracket.
2.Install left bottom log (#2) on left log support bracket in front of back log.
3.Install right bottom log (#3) on right log support bracket in front of back log.
4.Install top left log (#4) on top of left bottom log.
5.Install top right log (#5) on top of right bottom log.
CAUTION | During initial operation of the new |
a few hours to vent the odor. | |
| heater, burning logs will give off a paper |
| burning smell and orange flames will be |
| present. Simply open the windows for |
|
|
Figure 17 - Installing Logs to Grate
58D56002 | 19 |