Monessen Hearth CSVF20SNV manual Installing Thermostat Sensor Option Sold Separately, Screws Door

ELECTRICAL WIRING (MILLI-VOLT)

INSTALLING THERMOSTAT SENSOR (OPTION SOLD SEPARATELY)

1. Lift up on ash lip and pivot down to open control door.

2. Remove the face plate by removing the six (6) screws holding the faceplate in place. This will allow you to pull the faceplate away from the unit about 3" to 4". See Figure 13.

3. Slip the t-stat sensor behind the faceplate. Attach the t-stat sensor to the faceplate with 2 screws provided. Make sure the thermo bulb wire is on the bottom of the t-stat sensor. See Figure 14.

4. Attach wiring harnesses to back of t-stat sensor.
See Figure 14. Attach the other ends of the har-		Control
ness to either TP/TH and TH on control valve or	Screws	Door
to existing wiring harness with two (2) 0.250"		Ash	Face Plate
male spade terminals for remote t-stat operation.
		Lip	Screws
See Figure 12, page 16.

Figure 13 - Removing Face Plate from Unit

REMOTEC

ONTROL

PILOT

HEAT

Screws

THERMOSTAT

Knob

Thermo

Bulb

T-Stat

Sensor

Wiring

Harnesses

Figure 14 - Installing T-Stat Sensor and Control Knob

58D56002 17