Installation Instructions
INSTALL THE COOKTOP
10PREPARE THE COOKTOP
Remove the vent grille, vent filter, sealed burner module and the tape from the burner caps.
Turn the cooktop over (upside down) and gently place it on the styrofoam packing.
Unscrew (loosen) the side
Use styrofoam | Loosen side hold- |
to protect cooktop | down screws |
Install the plenum to the cooktop using 4 screws. The motor opening on the box goes toward the left side of the unit (the side with the grease jar lid).
10PREPARE THE COOKTOP (cont.)
Remove the 4 nuts and the vent guard from the blower assembly and set them aside.
Rotate the cooktop and plenum forward and carefully set it on its back edge on the styrofoam packing.
Install the blower assembly onto the plenum so that the blower exhaust is pointing down or back as needed. Push the bolts through the bolt holes in the plenum.
For back exhaust, position blower outlet in direction of this arrow
For down exhaust, position blower outlet in direction of this arrow
From the vent opening in the top of the cooktop, reinstall the vent guard over the bolts. Use the 4 nuts to secure the blower assembly and vent guard to the inside of the plenum.
4 Nuts | Vent guard |
(3/8″ socket |
|
required) |
|
26