Instructions
Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
Care and Cleaning Operating Instructions Safety
Sealed Burner Module
To Install the Sealed Burner Module:
1.Make sure that all control knobs are set to OFF.
2.Clean the cooktop basin to remove any grease accumulation. See the Care and Cleaning the Cooktop section.
3.With the back of the burner module tilted up and the two round openings and two pins facing toward the front, insert the module in the cooktop basin.
To Remove the Sealed Burner Module:
1.Make sure that all control knobs are set to OFF and that the cooktop is cool.
2.Lift up the edge of the burner module until the bottom of the module clears the edge of the basin.
IMPORTANT: Do not lift the module too high while it is still
4.Slide the burner module forward until the pins start to engage the white slotted receptacle.
5.Lower the back of the module into place and carefully slide it forward until the pins are fully engaged.
6.Place the burner caps on the burners. Carefully place the grate onto the module with the two tabs on the underside toward the center of
the cooktop.
3.Hold the module by the sides and pull it away from the slotted receptacle and brass orifices. Lift it out of the basin when it is completely unplugged.
4.Do not store or stack modules where they could fall or be damaged.
NOTE: The optional sealed burner module JXGB85 can replace the grill burner assembly.
Grill Module
The grill consists of a black grill grate and the grill burner. Only install the grill on the left side of your cooktop.
Consumer Support Troubleshooting Tips
To Install the Grill Module:
1. Make sure that all control knobs are set to OFF.
2. Position the grill burner with the two round tubes and two pins facing the front.
3. Slide the grill burner forward until the pins and ignitors are engaged in the white slotted receptacle; then lower the burner until it rests on the mounting pins.
To Remove the Grill Module:
1. | Make sure that all control knobs are |
| set to OFF and all grill components |
| are cool. |
2. | Remove the grill grate. |
3. | Lift the grill burner up slightly and |
| pull it away from the white slotted |
10 | receptacle and brass orifices. Lift it out |
of the basin when it is completely |
unplugged.
4.Carefully place the grill grate on the cooktop. The grate is designed to fit one way only. See the illustration.
NOTE: Before using the grill for the first time, heat the grill burner to remove the protective shipping coating. Heat the grill burner on HI for 10 minutes and use the vent system to remove any additional smoke during cooling.
4.Do not store or stack modules where they could fall or be damaged.
NOTE: The optional sealed burner module JXGB85 can replace the grill burner assembly.