Monessen Hearth MJ27PR, MJ27NR operating instructions Connecting the GAS, Gas Connection

Page 19

CONNECTING THE GAS

NOTICE: A qualified gas appliance installer must connect the heater to the gas supply. Consult all local codes.

CAUTION

Use new black iron or steel pipe. Internally tinned copper or copper tubing can be used per National Fuel Code, section 2.6.3, providing gas meets hydrogen sulfide limits, and where permitted by local codes. Gas piping system must be sized to provide minimum inlet pressure (Listed on Data Plate) at the maximum flow rate (BTU/Hr). Undue pressure loss will occur if the pipe is too small.

A manual shutoff valve must be installed upstream of the appliance. Union tee and plugged 1/8" NPT pressure tapping point should be installed upstream of the appliance. Figure 14

To Heater

Valve

Stainless

Flexible Tube

Pipe Coupling

Pipe

Locations that the Pressure Tapping

Point May Be Installed

Gas Supply

Inlet

Manual Shutoff

Valve

FP2007

Figure 14 - Gas Connection

IMPORTANT: Hold heater valve firmly with a wrench to prevent movement when connecting to inlet pipe.

CAUTION

Check gas type: The gas supply must be the same as stated on the heater’s rating plate. If the gas supply is different, DO NOT INSTALL THE HEATER. Contact your dealer for the correct model.

Always use an external regulator for all propane/LPG heaters and high pressure one to two-pound systems only, to reduce the supply tank pressure to a maximum of 13" w.c. This is in addition to the internal regulator in the heater valve.

86D0024

19

Image 19
Contents Natural Gas or Liquid Propane Control Type Millivolt Hi/Low Models MJ27NR, MJ27PRContents Gas Code, Ansi Z223.l/NFPA54 Important Safety InformationInstaller OwnerUtility gas wells. This gas is commonly Never connect unit to private nonKnown as wellhead gas Getting Started What you will need for installationMake sure you have received all parts Product Features and Specifications National Fire Protection Association, Inc General Installation InformationCodes American National Standards Institute, IncBTU / hr = Minimum Hearth Dimension Fireplace and Hearth DimensionsHeight of Restriction Minimum Depth of Fireplace/Firebox Placement in a fireplace with a restrictive barrierSidewall and Ceiling Clearances Clearances and Height RequirementsHeat Resistant Requirements for Safe InstallationMeasurement MJ27 Mantel, Shelf or Other Combustible Projection Heat Resistant Requirements for Safe Installation with Wood12 min Is an example of an unsafe mantel instal Minimum Clearance above Combustible Flooring Floor ClearanceFireplace Preparation Before installing in a solid fuel burningPaint by a qualified chimney cleaner Installing Vented ApplicationsAssembly procedure Installing Vented ApplicationsPlacing and Securing Appliance Gas Connection Connecting the GASMillivolt Valve Control Figure Checking GAS PressureAte Electrical Wiring MillivoltTo touch grate or Connecting Remote ReceiverDo not allow wires BurnerLOG Placement Install Log #8 Install Log #4 Place Flickering Bright Embers Place Flickering EmbersPlacing the decorative rock Andiron and rock installationANDIRON Installation Assembly InstructionsChecking the pilot flame Flame AppearanceOperating Instructions Checking the Burner FlameWhat to do if YOU Smell GAS Operating InstructionsTo Turn OFF GAS to Heater Cleaning and Servicing Operating Instructions / Cleaning and ServicingTurn appliance OFF and allow to cool before TroubleshootingServicing. Only a qualified service person Should service and repair the heaterGoes out when control Description Qty Replacement partsLogs Replacement Parts listDescription Qty MJ27 Please Read and Follow These 86D0024 If Warranty Service is Needed Lifetime WarrantyFive Year Warranty Basic WarrantyMhsc