Monessen Hearth MJ27PR, MJ27NR operating instructions LOG Placement

Page 23

LOG PLACEMENT

Before you begin — This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

WARNING

The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs and 2G-RW rock wool.

Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.

PlacE Rock Wool

Before installing logs, place rock- wool in dime size pieces evenly over small burner ports starting in front of the rear deflector shield towards the front. Avoid placing rock wool over the slots on rear and right side of burner and on large yellow flame ports on front of burner.

Wash hands after placing rock wool. Itching may occur.

 

warning

 

rock wool.

 

 

 

• Use only rock wool

 

 

 

provided with log set.

 

 

 

• Do not add additional

 

 

 

 

Dime-Sized

Pieces of Rock

Wool

Figure 18 - Place Rock Wool

FP2011

LG552

Figure 19 - Correct Rock Wool Placement

86D0024

23

Image 23
Contents Natural Gas or Liquid Propane Control Type Millivolt Hi/Low Models MJ27NR, MJ27PRContents Gas Code, Ansi Z223.l/NFPA54 Important Safety InformationInstaller OwnerKnown as wellhead gas Never connect unit to private nonUtility gas wells. This gas is commonly Make sure you have received all parts What you will need for installationGetting Started Product Features and Specifications National Fire Protection Association, Inc General Installation InformationCodes American National Standards Institute, IncBTU / hr = Minimum Hearth Dimension Fireplace and Hearth DimensionsHeight of Restriction Minimum Depth of Fireplace/Firebox Placement in a fireplace with a restrictive barrierSidewall and Ceiling Clearances Clearances and Height RequirementsMeasurement MJ27 Requirements for Safe InstallationHeat Resistant Mantel, Shelf or Other Combustible Projection Heat Resistant Requirements for Safe Installation with Wood12 min Is an example of an unsafe mantel instal Minimum Clearance above Combustible Flooring Floor ClearanceFireplace Preparation Before installing in a solid fuel burningPaint by a qualified chimney cleaner Installing Vented ApplicationsPlacing and Securing Appliance Installing Vented ApplicationsAssembly procedure Gas Connection Connecting the GASMillivolt Valve Control Figure Checking GAS PressureAte Electrical Wiring MillivoltTo touch grate or Connecting Remote ReceiverDo not allow wires BurnerLOG Placement Install Log #8 Install Log #4 Place Flickering Bright Embers Place Flickering EmbersPlacing the decorative rock Andiron and rock installationANDIRON Installation Assembly InstructionsChecking the pilot flame Flame AppearanceOperating Instructions Checking the Burner FlameWhat to do if YOU Smell GAS Operating InstructionsTo Turn OFF GAS to Heater Cleaning and Servicing Operating Instructions / Cleaning and ServicingTurn appliance OFF and allow to cool before TroubleshootingServicing. Only a qualified service person Should service and repair the heaterGoes out when control Description Qty Replacement partsDescription Qty MJ27 Replacement Parts listLogs Please Read and Follow These 86D0024 If Warranty Service is Needed Lifetime WarrantyFive Year Warranty Basic WarrantyMhsc