Assembly

Encore 1450 Non-Catalytic Woodburning Stove

Set Up Your Stove

Cast iron stoves are heavy, and it will take two to four people to move your Encore into position.

Wipe the protective coating of oil from the griddle with a clean dry rag or a paper towel.

	Install the handle
	on the griddle.
	First, place the
	griddle upside	ST516
	down at the edge	Fig. 28 Attach the griddle handle.
	of a ﬂat surface and	Fig. 28 Attach the griddle handle.
	of a ﬂat surface and
	assemble the handle as shown.

With the handle pointing 45° from its ﬁnal position, tighten the nut as far as possible with the pliers. Move the handle to its ﬁnal position while still holding the nut

with the pliers.

Install the Bottom Heat Shield

NOTE: The Bottom Heat Shield is required in most in- stallations. Refer to Floor Protection, Page 9, for further details.

1.Remove the four 10-24 x 1/2” hex head bolts from the corners of the ash drop on the stove bottom.

2.Align the bottom heat shield against the spacers with the outside air knockout hole toward the rear of the stove.

3.Secure the shield with the four (4) hex head bolts removed from the stove bottom previously.

4.Tighten securely.

Bottom Heat

Shield

Rear

Bolts

ST853

Fig. 29 Use four (4) bolts to attach the bottom heat shield.

Adjust the Leg Levellers

Lift the stove slightly so there is no weight on the leg while making the adjustment.

Reverse the Flue Collar (If Necessary)

Reverse the ﬂue collar by removing the two (2) screws that attach it to the back of the stove. Be sure the gas- ket around the ﬂue collar opening is in position when you screw the collar back onto the stove.

Attach the Primary Air Thermostat Handle

The primary air thermostat handle is the smaller of the two black handles. Secure the handle to the stub on the right side of the stove with an 8-32 x 2” slot head machine screw.

Attach the Damper Handle

Use the 1/4” -20 x 3” screw to attach the damper handle to the damper stub on the left side.

Assemble the Removable Insert Handle

The white removable insert handle opens and closes the front doors. Remove after each use so it won’t get hot. Store it in the handle holder installed behind the right front leg. Assemble the handle by passing the 3³⁄₈" screw through the ceramic shaft and into the bright metal nub. Tighten carefully until snug.

ST635

Fig. 30 Attach thermostat handle.

ST540

Fig. 31 Assemble the front door handle.

30002425