Vermont Casting Encore NC 1450 installation instructions Ash Removal and Disposal

Page 25
Encore 1450 Non-Catalytic Woodburning Stove
Remove the ash pan, making sure to keep it level.
To keep the cover from sliding off and to keep ash from falling on the floor, do not tilt the ash pan for- ward.
If the stove is in operation, close the ash door while disposing of the ash.
Properly dispose of the ash in a metal container with a tight-fitting lid. Store the container outdoors away from all combustible material.
Return the ash pan to its original position in the stove, and close and latch the ash door.
Do not operate the stove with the ash door open. This will result in over-firing, and could cause dam- age to the stove, void the warranty, or even lead to a house fire.
Empty the ash pan regularly, typically every one to three days. The frequency will vary depending on how you operate your Encore: ash will accumulate faster at higher heat outputs.
Remove ash frequently and place it outdoors in a metal container with a tight-fitting lid. Place the closed container of ash on a noncombustible floor or on the ground, well away from all combustible materials, pend- ing final disposal. If the ash is disposed of by burial in soil or otherwise locally dispersed, it should be kept in the closed container until all cinders have thoroughly cooled.
You can use wood ash as a garden fertilizer.
CAUTION: Never use your household or shop vacuum cleaner to remove ash from the stove; always remove and dispose of the ash properly.
25

Ash Removal and Disposal

You should remove ash before it reaches the top of the ash pan. Check the level at least once a day. Every few days, clear any ash from the outer edges of the firebox and the cavity areas of the stove. Most of the ash will fall through the grate. Slice or stir the ash with a shovel or poker so that it falls through the grate slots.

Open

Close

ST545

Fig. 41 Turn the handle to the ash pan compartment clock- wise to open and counterclockwise to close.

IMPORTANT: Check the level of ash in the ash pan before reloading the stove. If the ash level is close to the top edge of the pan, empty the pan according to this procedure:

Open the damper.

Open the griddle or front doors, and use a shovel or poker to stir excess ash through the ash slots in the grate down into the ash pan.

Close the griddle or doors, and unlatch the ash door. It will pivot, swinging the ash pan out of the stove.

Slide the cover onto the pan, making sure it is se- curely closed. (Fig. 42)

ST566

Fig. 42 Be sure the cover is securely attached before remov- ing the ash pan.

30002425

Image 25
Contents Encore Welcome Table of ContentsSpecifications Encore dimensionsOutside Air InstallationChimney Height Masonry Chimneys What Kind of Chimney to UsePrefabricated Chimneys Chimney SizeSingle-wall Chimney Connectors Chimney Connector GuidelinesDouble-wall Chimney Connectors Freestanding Installations Securing the Single-wall Connector to a Masonry ChimneyFireplace Installations Above the FireplaceWall Pass-Throughs Through the FireplaceAn approved wall pass-through for the United States Floor ProtectionCanada Floor Protection for Fireplace InstallationsReducing Clearances Safely with Shields Keep the Stove a Safe Distance From Surrounding MaterialsWall Shields Fireplace Mantel and Trim Shields Chimney Connector Heat ShieldsConstruction Requirements Alcove InstallationsCutaway perspective of acolve installation Unprotected Surfaces Protected Surfaces Encore NC Clearance ChartBcef Encore Clearance DiagramsWall Shield Requirements for Common Installations Corner Parallel Installations Assembly Fan installation Kit # Fan Kit InstallationEncore NC Controls OperationSingle Air Control Regulates Heat Output and Burn Time Damper Directs Air Flow Within the StoveAndirons Help Protect the Glass Infrared Reflective Glass Panels For Clear Fire ViewingBurn Only High-Quality Wood Conditioning Your Stove Use the Air Control Settings That Work Best for YouStarting and Maintaining a Wood Fire Add larger pieces of wood as the fire begins to burn well Refuel While the Embers Are Still HotAsh Removal and Disposal Draft Management Creosote Draft TestingFuel Back-puffingMaintenance Tighten the Damper Handle as Needed Adjust the Door LatchesReplace the Stove Gaskets as Needed All Gasketed Construction Adjust the Door If NecessaryChimney System Creosote Chimney Connector Maintenance Schedule StoveEncore Non-Catalytic Woodburning Stove Encore Woodburning Stove Shell Enamel Parts Encore NC Model Limited Lifetime Warranty CFM Corporation