Vermont Casting Encore NC 1450 Fan Kit Installation, Fan installation Kit #

Page 20

Encore 1450 Non-Catalytic Woodburning Stove

Fan Kit Installation

1.Remove the sheet metal outer back shown in Figure 32.

2.Attach the fan assembly at the bottom edge of the in- ner back with two (2) 1/4-20 x 3/4” hex head screws and one (1) 1/4” star washer.

3.Attach snapstat to the mounting holes on the un- derside of the bottom with two (2) 1/4-20 pan head screws.

4.Attach the rheostat holder, (provided with stove), under the right wing of the bottom heat shield with two (2) #10 sheet metal screws.

5.Attach the rheostat to its holder by inserting the rheostat control shaft through the holder hole. Install the retaining ring and rheostat onto the shaft.

6.Secure the rheostat cable to the underside of the bottom heat shield using the wire tie provided on the hole at the right rear edge of the heat shield.

7.Fan will not operate until stove reaches approximate- ly 109°F.

8.Replace the sheet metal outer back.

Rheostat

Knob

Rheostat

Snapstat Screws

Fig. 32 Fan installation (Kit # 2767).

ST848

20

30002425

Image 20

Contents Encore Table of Contents WelcomeEncore dimensions SpeciﬁcationsChimney Height InstallationOutside Air What Kind of Chimney to Use Masonry ChimneysPrefabricated Chimneys Chimney SizeDouble-wall Chimney Connectors Chimney Connector GuidelinesSingle-wall Chimney Connectors Securing the Single-wall Connector to a Masonry Chimney Freestanding InstallationsFireplace Installations Above the FireplaceThrough the Fireplace Wall Pass-ThroughsFloor Protection An approved wall pass-through for the United StatesFloor Protection for Fireplace Installations CanadaWall Shields Keep the Stove a Safe Distance From Surrounding MaterialsReducing Clearances Safely with Shields Chimney Connector Heat Shields Fireplace Mantel and Trim ShieldsAlcove Installations Construction RequirementsCutaway perspective of acolve installation Encore NC Clearance Chart Unprotected Surfaces Protected SurfacesEncore Clearance Diagrams BcefWall Shield Requirements for Common Installations Corner Parallel Installations Assembly Fan Kit Installation Fan installation Kit #Operation Encore NC ControlsSingle Air Control Regulates Heat Output and Burn Time Damper Directs Air Flow Within the StoveBurn Only High-Quality Wood Infrared Reﬂective Glass Panels For Clear Fire ViewingAndirons Help Protect the Glass Starting and Maintaining a Wood Fire Use the Air Control Settings That Work Best for YouConditioning Your Stove Refuel While the Embers Are Still Hot Add larger pieces of wood as the ﬁre begins to burn wellAsh Removal and Disposal Draft Management Draft Testing CreosoteFuel Back-pufﬁngMaintenance Replace the Stove Gaskets as Needed Adjust the Door LatchesTighten the Damper Handle as Needed Chimney System Creosote Adjust the Door If NecessaryAll Gasketed Construction Maintenance Schedule Stove Chimney ConnectorEncore Non-Catalytic Woodburning Stove Encore Woodburning Stove Shell Enamel Parts Encore NC Model Limited Lifetime Warranty CFM Corporation