®
UNVENTED NATURAL GAS FIREPLACE
OPERATING
FIREPLACE
Continued
7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
Note: If pilot goes out, repeat steps 3 through 7.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.
8.Slightly depress and turn control
knob counterclockwise 
C-clockwise
VARIABLE CONTROL
OPERATION
The variable control valve can be set to any heat setting and flame height desired, by simply turning the control knob until that setting is attained. Even the lowest setting provides realistic flames and glowing em- bers from two burners. Selecting higher settings produces greater heat output. This results in increased heating comfort.
WARNING: Do not operate heater between locked positions.
CAUTION: Do not try to adjust heating levels by using the equip- ment shutoff valve.
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 5 under Light- ing Instructions, page 15.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 8, column 1.
Control Knob
IGNITOR
Ignitor Button
Figure 29 - Control Knob and Ignitor Button Location
Ignitor Electrode
Thermocouple | Pilot Burner |
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise Clockwise
to the HIGH position.
2.Slightly depress control knob and
turn clockwise Clockwise
to the PILOT position.
3.Slightly depress control knob and
turn clockwise Clockwise
to the OFF position.
Shutting Off Burners Only (pilot stays lit)
1.Turn control knob clockwise to the HIGH position.
2.Press in and turn clockwise to the PILOT position.
Clockwise
Clockwise
Figure 30 - Pilot
Continued
For more information, visit www.desatech.com | 16 | 107157 |