OWNER’S MANUAL
PRODUCT IDENTIFICATION
Middle Log
Front Burner
Front Log
Base Assembly 
Figure 1 - Log Base Assembly, Split Oak Set
Crossover Log
Rear Log
Rear
Burner
Top Outer
Casing
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
WARNING: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.
Top Louver
Assembly
Fireplace
Hood
Firebox Support
Screen
Assembly
Figure 2 - Fireplace
2.Locate two screws above top corners of the fireplace screen. Remove and discard these screws. Lift fireplace screen up and pull out to remove.
3.Remove protective packaging applied to logs, log base assembly, and fireplace.
4.Remove fireplace hood from carton insert.
5.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace.
Optional Blower
Assembly
(Not Included)
Bottom
Louver
Assembly
107157 | 3 | For more information, visit www.desatech.com |