®
UNVENTED NATURAL GAS FIREPLACE
INSTALLATION
Continued
CHECKING GAS
CONNECTIONS
WARNING: Test all gas pip- ing and connections for leaks after installing or servicing. Cor- rect all leaks at once.
WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.
Pressure Testing Gas Supply Piping System
Test Pressures In Excess Of 1/2 PSIG (3.5 kPa)
Test Pressures Equal To or Less Than 1/2 PSIG (3.5 kPa)
1.Close equipment shutoff valve (see Fig- ure 20).
2.Pressurize supply piping system by either using compressed air or opening main gas valve located on or near gas meter.
3.Check all joints from gas meter to equip- ment shutoff valve (see Figure 21). Ap- ply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.
4.Correct all leaks at once.
Open
Equipment
Shutoff
Valve
Closed
Figure 20 - Equipment Shutoff Valve
Pressure Testing Fireplace Gas Connections
1.Open equipment shutoff valve (see Fig- ure 20).
2.Open main gas valve located on or near gas meter.
3.Make sure control knob of fireplace is in the OFF position.
4.Check all joints from equipment shutoff valve to gas control valve (see Figure 21). Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Light fireplace (see Operating Fire- place, pages 14 through 17). Check all other internal joints for leaks.
7.Turn off fireplace (see To Turn Off Gas to Appliance, page 15
1.Disconnect fireplace with its main gas valve (control valve) and equipment shutoff valve from gas supply piping sys- tem. Pressures in excess of 1/2 psig will damage fireplace gas regulator.
2.Cap off open end of gas pipe where equipment shutoff valve was con- nected.
3.Pressurize supply piping system by either using compressed air or opening main gas valve located on or near gas meter.
4.Check all joints of gas supply piping system. Apply mixture of liquid soap and water to gas joints. Bubbles form- ing show a leak.
5.Correct all leaks at once.
6.Reconnect fireplace and equipment shutoff valve to gas supply. Check re- connected fittings for leaks.
,Q¢,,,,,,,,QQQQQQQQ¢¢¢¢¢¢¢¢,Q¢ |
Gas Control Valve |
Figure 21 - Checking Gas Joints
Equipment Shutoff Valve
Gas Meter
For more information, visit www.desatech.com | 12 | 107157 |