Vanguard Heating SBVBN(A), SBVBP(A) REMOVING/REPLACING Glass Door, Installing Remote Receiver

®

B-VENT FREESTANDING FIREPLACE

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES - GHRC AND GHRCT SERIES

Installing Remote Receiver

1.Open bottom door on stove body and locate the switch plate on the left of the valve bracket.

2.Unscrew switch plate (see Figure 34).

3.Disconnect wires from THTP and TH on control valve that lead to the switch (see Figure 31, page 15). Discard switch plate, screws, and nuts.

4.Install battery into receiver battery clip and connect to terminals (see Figure 35).

5.Place receiver into valve bracket and align holes (see Figure 36).

6.Use push-in fasteners included with receiver to secure to bracket.

7.Connect the wires from the receiver to the valve at TH and THTP (see Figure 31, page 15).

LO

H

I

OFF	I
	P
	L
O	O
	T
N

Figure 34 - Removing Switch Plate

Receiver

Terminal

Wires

Battery

Clip

9-Volt Battery

Figure 35 - Installing Battery in Receiver

LO

H

I

OFF	I
	P
	L
ON	O
	T

Figure 36 - Installing Remote Receiver

Installing 9-Volt Battery in Hand- Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit

2.Attach terminal wires to a 9-volt bat- tery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote con- trol unit.

	Battery	Remote
		Control Unit
Terminal	Cover
Wires
9-Volt
Battery

Battery Housing

Figure 37 - Installing Battery in Hand- Held Remote Control Unit

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 25.

1.Remove 2 bolts from bottom of stove and one from the top of stove to remove front panel (see Figure 38).

2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 39).

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 39).

4.To replace glass door, follow the above instructions in reverse.

Bolt

Bolt

Stove Front Panel

Figure 38 - Removing Front Panel from Stove

Screw

Glass

Door

Figure 39 - Removing Glass Door from Firebox Insert

16 105500