Empire Comfort Systems VFSM-30-3 installation instructions Introduction, New Installation

Page 5

INTRODUCTION

IMPORTANT: Read all instructions carefully before starting installation. Failure to follow these installation instructions may result in a possible fire hazard and will void the warranty.

Save this manual for future reference.

Please read this manual before installing and using the appliance. Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with unvented room heater/vented decorative appliance.

3.Installer should show owner how to start and operate unvented room heater/vented decorative appliance.

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of an unvented room heater/vented decorative appliance.

This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited by state or local codes.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

New Installation

VFSV Model - variable does not operate-ON is OFF/OFF is ON-wires into the back of receiver are reversed.

Solid-fuels shall not be burned in a fireplace where a vented decorative appliance is installed.

A vented decorative appliance must be installed only in a solid-fuel burning fireplace with a working flue and constructed of non-combustible material.

Any alteration of the original design, installed other than as shown in these instructions or use with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

Important

All correspondence should refer to complete Model Number, Serial Number and type of gas.

Attention: During initial use of log you will detect an odor as the log is cured.

Notice: During initial firing of this unit, its paint will bake out, and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

WARNING: This appliance is for installation only in a solid-fuel burning masonry or UL 127 factory-built fireplace or in a listed ventless firebox enclosure. It has been design certified for these installations. Exception: DO NOT install this appliance in a factory- built fireplace that includes instructions stating it has not been tested or should not be used with unvented gas logs.

WARNING: Any modification to this unvented gas heater or its controls can be dangerous. Improper installation or use of the heater can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning.

Well Head Gas Installations

Some natural gas utilities use "well head" gas.This may affect the Btu output of the unit. Contact the gas company for the heating value. Contact the manufacturer or your gas company before changing spud/orifice size.

ACCESSORIES

 

 

Description

Color

 

 

 

For use with VFSV, VFSM and VFSR models

 

 

 

 

EK-1

Embers Kit

 

 

 

 

ELH-1

Fireplace Hood for Vent-Free Logs

Black

 

 

 

ELH-2

Fireplace Hood for Vent-Free Logs

Brass

 

 

 

For use with VFSR models only

 

 

 

 

FRBC

Battery Operated Remote Control

 

 

 

 

FRBTC

Battery Operated Remote Control with Thermostat

 

 

 

 

FREC

Electric Remote Control

 

 

 

 

FWS

Wall Switch

 

 

 

 

TMV

Wall Thermostat, Millivolt - Reed Switch

 

 

 

 

PRODUCT SPECIFICATION

 

 

 

Natural Gas

 

 

Propane Gas

 

 

 

Variable

Millivolt

Manual

Variable

Millivolt

Manual

Regulator pressure setting

 

3.5" W.C.

3.5" W.C.

6.0" W.C.

10.0" W.C.

10.0" W.C.

10.0" W.C.

Gas inlet pressure

Max.

10.5" W.C.

10.5" W.C.

10.5" W.C.

13.0" W.C.

13.0" W.C.

13.0" W.C.

 

Min.

5.0" W.C.

5.0" W.C.

7.0" W.C.

11.0" W.C.

11.0" W.C.

11.0" W.C.

 

 

 

 

 

 

 

 

 

 

 

BTUH

BTUH

BTUH

Model

Gas

Valve Type

Max. Rate

Med. Rate

Min. Rate

VFSV-16

Natural

Variable

25,000

—

17,500

VFSV-16

Propane

Variable

22,500

—

15,750

VFSR-16

Natural

Millivolt

25,000

—

17,500

VFSR-16

Propane

Millivolt

22,500

—

15,750

VFSV-18

Natural

Variable

32,000

—

19,000

VFSV-18

Propane

Variable

32,000

—

19,000

VFSR-18

Natural

Millivolt

32,000

—

22,000

VFSR-18

Propane

Millivolt

32,000

—

22,000

VFSM-18

Natural

Manual

32,000

27,000

22,000

VFSM-18

Propane

Manual

32,000

27,000

22,000

VFSV-24

Natural

Variable

36,000

—

20,000

VFSV-24

Propane

Variable

36,000

—

20,000

VFSR-24

Natural

Millivolt

36,000

—

25,000

VFSR-24

Propane

Millivolt

36,000

—

25,000

VFSM-24

Natural

Manual

36,000

27,000

22,000

VFSM-24

Propane

Manual

36,000

27,000

22,000

VFSV-30

Natural

Variable

38,000

—

20,000

VFSV-30

Propane

Variable

38,000

—

20,000

VFSR-30

Natural

Millivolt

38,000

—

26,000

VFSR-30

Propane

Millivolt

38,000

—

26,000

VFSM-30

Natural

Manual

38,000

27,000

22,000

VFSM-30

Propane

Manual

38,000

27,000

22,000

18954-2-0107

Page 5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Millivolt Variable Manual Installation InstructionsTable of Contents Do not Tamper with Pilot Light Safety Important Safety InformationCarbon Monoxide Poisoning MAY Lead to DeathLP-GAS Warning Odor Safety Information for Users of LP-GASIntroduction New InstallationMake sure you have received all parts General InformationBefore you get started Glass Doors ClearancesClearances Fireplace Preparation Combustible MaterialInstalling Damper Clamp Figure Installing AS a Vented ApplianceBefore Fully Installing the Appliance Pressure Testing of the Gas Supply System Installing a New Main Gas CockGAS Supply Recommended Gas Pipe DiameterOperation INSTRUCTIONS/FLAME Appearance Placement of Glowing Embers and Lava RockPlacing Lava Rock in Front of Burner on Fireplace Floor Variable Figure Millivolt Figure Manual FigureWhat to do if YOU Smell GAS VFSR-16,18,24,30 Lighting InstructionsLighting Instructions VFSM-18,24,30 Lighting Instructions Vfsr Pilot Pilot Flame CharacteristicsVfsv and Vfsm Pilot Correct Pilot Flame Pattern Incorrect Pilot Flame PatternTurn OFF Heater and Allow to Cool Before Cleaning Cleaning and ServicingVfsv WiringVfsr Heater produces a whistling noise when main burner is lit Gas odor even when control knob is in OFF positionNew Installation Appliance produces unwanted odorsIndex Part Description Parts ListParts View HOW to Order Repair Parts Service Notes Service Notes

VFSM-30-3 specifications

The Empire Comfort Systems VFSM-30-3 is a state-of-the-art vent-free gas fireplace that combines functionality with aesthetic appeal. Ideal for homes without traditional venting systems, this fireplace brings warmth and a cozy ambiance to any space while maintaining an efficient energy usage standard.

One of the main features of the VFSM-30-3 is its impressive heat output. With a heating capacity of up to 30,000 BTUs, it effectively warms areas up to 1,200 square feet, making it suitable for both small and large living spaces. The unit’s design incorporates a durable steel construction, ensuring longevity and resistance to wear over time.

The versatility of the Empire VFSM-30-3 is notable, as it can be powered by either natural gas or propane, allowing homeowners flexibility in fuel choice. It also features an adjustable flame height, giving users the option to create their desired level of warmth and ambiance. This is complemented by its realistic log set, which enhances the visual appeal, replicating the look of a traditional wood-burning fireplace.

Another significant characteristic of the VFSM-30-3 is its advanced vent-free technology. This innovative system allows for efficient combustion without the need for a chimney or flue, greatly reducing installation costs and complexities. The vent-free design also ensures that 100% of the heat generated is utilized within the room, providing exceptional energy efficiency.

Safety is a top priority with the Empire VFSM-30-3. The fireplace comes equipped with an oxygen depletion sensor, which automatically shuts off the gas supply if the oxygen levels fall below a safe threshold, providing peace of mind for users.

Installation of the VFSM-30-3 is straightforward, with options for wall mounting or placing it on a hearth. This flexibility allows homeowners to integrate the fireplace into their existing décor seamlessly. Its variety of trim options and finishes further empowers users to personalize their fireplace, ensuring it complements their home’s interior design.

In summary, the Empire Comfort Systems VFSM-30-3 offers a reliable and stylish heating solution for those seeking the charm of a gas fireplace without the challenges of traditional venting. Its combination of efficiency, safety features, and customizable options makes it a remarkable choice for any home.
Top Page Image Contents