Hubbell Electric Heater Company HSE, HE manual Temperature High Limit Switch, Heating Element

Page 6

TEMPERATURE HIGH LIMIT SWITCH

As a safety device, a surface mounted high temperature cut-off switch with manual reset, factory set at 190° F is provided. In the event of an over-temperature condition, the thermostat will disengage the power from the unit, (in the HSE model the thermostat will disengage the operating coils in the magnetic contactor). The high limit must be manually reset thereafter to restart the heater.

Manual Reset

HEATING ELEMENT

The water heater is supplied with an electric immersion heating element assembly(s), composed of incoloy or copper sheathed elements that are brazed into a brass flange. Each assembly is fastened to a corresponding tank flange using a gasket and four (4) 3/8-16 x 1-inch long hex head steel bolts and nuts. See drawing for voltage and power ratings.

3-Phase Incoloy Sheathed Element

Single Phase Copper Sheathed Element

6

Image 6
Contents Electric Heater Company Hubbell Electric Heater Company STRATFORD, CTTable of Contents Section Title Page Tank Connections Section I General Description and ConstructionTank Control ThermostatTemperature High Limit Switch Heating ElementMagnetic Contactor HSE Models Only Outer Shell and InsulationSection II Installation Water Heater PlacementPiping Installation Electrical Installation Filling the HeaterFinal Checks Freezing Section III Scheduled Maintenance and OperationMaintenance and Operation Quarterly InspectionAnnual Inspection Section IV Troubleshooting Symptom Probable Cause Corrective Action / RemedySection V Servicing & Replacement of Parts Surface Temperature High Limit CUT-OFFHeating Element Page Immersion Thermostat Magnetic Contactor Relief Valve Delta WYE Single Phase Element Chart Torque Values