Empire Comfort Systems CIVF-25-21 installation instructions Assembly of Stove Casting

Page 12

ASSEMBLY OF STOVE CASTING (continued)

11.Refer to Figure 9, attach casting front to casting by using the (4) retaining tabs on the casting front. The (2) top, retaining tabs on the casting front will be placed behind the (2) top, locator tabs on the front of the casting sides. The (2) bottom, retaining tabs will be inserted into the (2) 9/16" slots on the front, leg pads. Place the top, retaining tabs behind the top, locator tabs as you pivot inward the bottom of the casting front in order to insert the bottom, retaining tabs into the slots.

Figure 9

12.The following procedure will provide a snug fit between the casting front and the casting sides. Grasp the right, front leg, push inward on the leg in order to provide a snug fit between the casting front and the casting side. Continue to hold the right, front leg as you completely tighten the (2) 3/8" bolts that attach the leg pad to the right, casting side. Repeat procedure for left, front leg to achieve a snug fit between the casting front and the casting side.

13.Remove the casting front from the casting.

14.Refer to Figures 10 and 11, the appliance firebox can now be inserted into the casting. Center the firebox in the casting. Attention: Remove (1) Phillips-head screw in the top of the valve cover. The screw is used to secure the valve cover in place during shipping. The (1) Phillips-head screw can be discarded.

15. Refer to Figure 12, align (4) clearance holes on rear cover with screw holes in (2) lower mounting brackets and (2) upper mounting brackets on firebox.Attach firebox to rear cover with

(4) 10 x 1/2" screws.

16. Attach casting front to casting as described in Step 11.

17. Place the casting top onto the casting. The casting top nests into the casting.

18. Insert center grill, left grill and right grill into casting top.

19.Level appliance by adjusting leveling bolts.

20.Assembly of stove casting is completed.

Figure 10

Figure 11

Page 12

16938-3-0806

Image 12
Contents Installation Instructions Table of Contents Important Safety Information Minimize this effect. The use of this fan will also improveSafety Information for Users of LP-GAS LP-GAS Warning OdorSpecifications Instructions to InstallerQualified Installing Agency IntroductionUnusually Tight Construction Unusually tight construction is defined as construction whereInstalling a New Main Gas Cock Pressure Testing of the Gas Supply SystemRecommended Gas Pipe Diameter Checking Manifold PressureInstallation on Rugs and Tile ClearancesClearances Figures 2, 3 Appliance Hardware Package Parts List Appliance Hardware PackageAssembly of Stove Casting Detailed Instructions Follow16938-3-0806 Assembly of Stove Casting Optional Stone Inlay Installation Wire Channel InstallationInstallation of Optional Stone Inlay Parts ListLOG Placement Operating GuidelinesInitial Lighting Figure Standing Pilot OperationFor Your Safety Read Before Lighting Lighting InstructionsPilot Flame Characteristics Correct Pilot Flame Pattern Incorrect Pilot Flame PatternMain Burner Flame Characteristics Cleaning the Log Set and FireboxWiring Maintenance Wiring Diagram FigureTroubleshooting Delayed ignition of main burnerMain burner does not light after ODS/pilot is lit HOW to Order Repair Parts Parts List for Stove Casting Parts List for CIVF-25-21Parts View for Stove Casting Parts View for CIVF-25-21 Optional Blower Installation Instructions Installing Optional CIB-2 BlowerFan Control Cleaning WiringBlower Motor Index Part DescriptionService Notes