Empire Comfort Systems CIVF-25-21 installation instructions Main Burner Flame Characteristics

Page 17

MAIN BURNER FLAME CHARACTERISTICS

Figure 18 shows a correct main burner flame pattern. Figure 19 shows an incorrect main burner flame pattern.

If main burner flame pattern is incorrect, as shown in Figure 19

See Troubleshooting, pages 20-21.

Correct Main Burner Flame

Figure 18

Incorrect Main Burner Flame

Figure 19

Cleaning and Maintenance / Main Burner Warning: Turn off heater and let cool before cleaning

After use, cleaning of the main burner may be required for the proper flame. The main burner may be cleaned by applying air pressure to the ports on the main burner.

Cleaning the Log Set and Firebox

During the annual inspection and maintenance appointment, the service person should clean dust, lint, and any light accumulation from the logs and the firebox area. An extra-soft brush should be used on the logs as they are extremely fragile; a vacuum cleaner may be used on the firebox. If at any time the logs cannot be removed or installed without forcing, the cause must be found. The logs must never be forced.

CAUTION: The ceramic logs are durable when handled and installed properly. However, they are delicate and may be damaged easily if not handled with care. Handling damage to the ceramic logs is not covered by warranty.

DO NOT HANDLE LOGS WHILE THEY ARE HOT. ALLOW PLENTY OF TIME FOR THE APPLIANCE TO COOL COM- PLETELY BEFORE HANDLING.

PLEASE NOTE

It is normal for appliances fabricated of steel to give off some expansion and/orcontraction noised during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.

16938-3-0806

Page 17

Image 17
Contents Installation Instructions Table of Contents Minimize this effect. The use of this fan will also improve Important Safety InformationLP-GAS Warning Odor Safety Information for Users of LP-GASInstructions to Installer SpecificationsQualified Installing Agency IntroductionUnusually tight construction is defined as construction where Unusually Tight ConstructionPressure Testing of the Gas Supply System Installing a New Main Gas CockRecommended Gas Pipe Diameter Checking Manifold PressureClearances Figures 2, 3 Installation on Rugs and TileClearances Appliance Hardware Package Appliance Hardware Package Parts ListDetailed Instructions Follow Assembly of Stove Casting16938-3-0806 Assembly of Stove Casting Wire Channel Installation Optional Stone Inlay InstallationInstallation of Optional Stone Inlay Parts ListOperating Guidelines LOG PlacementInitial Lighting Figure Standing Pilot OperationLighting Instructions For Your Safety Read Before LightingCorrect Pilot Flame Pattern Incorrect Pilot Flame Pattern Pilot Flame CharacteristicsCleaning the Log Set and Firebox Main Burner Flame CharacteristicsWiring Wiring Diagram Figure MaintenanceMain burner does not light after ODS/pilot is lit TroubleshootingDelayed ignition of main burner HOW to Order Repair Parts Parts List for CIVF-25-21 Parts List for Stove CastingParts View for Stove Casting Parts View for CIVF-25-21 Fan Control Optional Blower Installation InstructionsInstalling Optional CIB-2 Blower Wiring CleaningBlower Motor Index Part DescriptionService Notes