Wire Channel Installation

OPTIONAL STONE INLAY INSTALLATION

Whenever the standard grill top is replaced with a stone inlay you must install the top shield and heat shield, which are provided with the stone inlay.

Installation of Optional Stone Inlay

1.Remove left grill, center grill and right grill from casting top.

2.Remove casting top from outer casting.

3.Place the casting top on a non-abrasive surface in order to protect the porcelain ﬁnish. The exterior of the casting top should be facing the non-abrasive surface.

4.Attach 11 5/8" x 11 5/8" top shield to the interior of the casting top with (1) 3/8" bolt provided in hardware package.

5.Locate the (4) screw holes on the heat exchanger top. The screw holes are 8 3/4" apart. Position the angled front edge on the 12" x 19 3/8" heat shield with the front of the ﬁrebox. Align the (4) tabs with clearance holes on the 12" x 19 3/8" heat shield with the (4) screw holes on the heat exchanger top. Attach the 12" x 19 3/8" heat shield to the heat exchanger top with (4) 1/2" hex-head screws provided in hardware package.

6.Place the casting top onto the casting. The casting top nests into the casting.

7.Insert center stone inlay, left stone inlay and right stone inlay into casting top.

8.Installation of stone inlay is completed.

Parts List

Part Description	Part	Quantity
	Number	Supplied
11 5/8" x 11 5/8" Top Shield	CI-091	1
12" x 19 3/8" Heat Shield	CI-092	1
3/8" Bolt	R-3646	1
1/2" Hex-Head Screw	R-2737	4

The ON/OFF/REMOTE switch with harness is factory installed into the switch box. After the ﬁrebox is installed into the casting the wire channel can be installed.

1.Attach switch box on the left side of rear cover with (2) 10 x 1/2" screws.

2.Route wires from ON/OFF/REMOTE switch within wire channel.

3.Attach wire channel on the left side of the rear cover with (4) 10 x 1/2" screws.

4.Attach the black and green (wires) female

push-ons to the TH/TPand TH (two outside male tabs) terminals on gas valve.

Figure 12

16938-3-0806

Page 13