Empire Products DVC-35IPT-1 Safety Information for Users of LP-GAS, Measure under any condition

Page 4

SAFETY INFORMATION FOR USERS OF LP-GAS

Propane (LP-Gas) is a flammable gas which can cause fires and explosions. In its natural state, propane is odorless and colorless. You may not know all the following safety precau- tions which can protect both you and your family from an accident. Read them carefully now, then review them point

by point with the members of your household. Someday when there may not be a minute to lose, everyone’s safety will depend on knowing exactly what to do. If, after reading the following information, you feel you still need more information, please contact your gas supplier.

LP-GAS WARNING ODOR

If a gas leak happens, you should be able to smell the gas because of the odorant put in the LP-Gas.

That’s your signal to go into immediate action!

Do not operate electric switches, light matches, use your phone. Do not do anything that could ignite the gas.

Get everyone out of the building, vehicle, trailer, or area. Do that IMMEDIATELY.

Close all gas tank or cylinder supply valves.

LP-Gas is heavier than air and may settle in low areas such as basements. When you have reason to suspect a gas leak, keep out of basements and other low areas. Stay out until firefighters declare them to be safe.

Use your neighbor’s phone and call a trained LP-Gas service person and the fire department. Even though you may not continue to smell gas, do not turn on the gas again. Do not re-enter the building, vehicle, trailer, or area.

Finally, let the service man and firefighters check for escaped gas. Have them air out the area before you return. Properly trained LP-Gas service people should repair the leak, then check and relight the gas appliance for you.

NO ODOR DETECTED - ODOR FADE

Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. You must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor. Sometimes other odors in the area mask the gas odor. People may not smell the gas odor or their minds are on something else. Thinking about smelling a gas odor can make it easier to smell.

The odorant in LP-gas is colorless, and it can fade under some circumstances. For example, if there is an underground leak, the movement of the gas through soil can filter the odorant. Odorants

in LP-Gas also are subject to oxidation. This fading can occur if there is rust inside the storage tank or in iron gas pipes.

The odorant in escaped gas can adsorb or absorb onto or into walls, masonry and other materials and fabrics in a room. That will take some of the odorant out of the gas, reducing its odor intensity.

LP-Gas may stratify in a closed area, and the odor intensity could vary at different levels. Since it is heavier than air, there may be more odor at lower levels. Always be sensitive to the slightest gas odor. If you detect any odor, treat it as a serious leak. Immediately go into action as instructed earlier.

SOME POINTS TO REMEMBER

Learn to recognize the odor of LP-gas. Your local LP-Gas

to set too long before refilling. Cylinders and tanks which

Dealer can give you a “Scratch and Sniff” pamphlet. Use it

have been out of service for a time may develop internal rust

to find out what the propane odor smells like. If you suspect

which will cause odor fade. If such conditions are suspected

that your LP-Gas has a weak or abnormal odor, call your

to exist, a periodic sniff test of the gas is advisable. If you

LP-Gas Dealer.

have any question about the gas odor, call your LP-gas

• If you are not qualified, do not light pilot lights, perform

dealer. A periodic sniff test of the LP-gas is a good safety

measure under any condition.

service, or make adjustments to appliances on the LP-Gas

 

system. If you are qualified, consciously think about the odor

• If, at any time, you do not smell the LP-Gas odorant and you

of LP-Gas prior to and while lighting pilot lights or perform-

think you should, assume you have a leak. Then take the same

ing service or making adjustments.

immediate action recommended above for the occasion when

• Sometimes a basement or a closed-up house has a musty

you do detect the odorized LP-Gas.

 

smell that can cover up the LP-Gas odor. Do not try to light

• If you experience a complete “gas out,” (the container is

pilot lights, perform service, or make adjustments in an area

under no vapor pressure), turn the tank valve off immediately.

where the conditions are such that you may not detect the

If the container valve is left on, the container may draw in

odor if there has been a leak of LP-Gas.

some air through openings such as pilot light orifices. If this

• Odor fade, due to oxidation by rust or adsorption on walls

occurs, some new internal rusting could occur. If the valve is

left open, then treat the container as a new tank. Always be

of new cylinders and tanks, is possible. Therefore, people

sure your container is under vapor pressure by turning it off

should be particularly alert and careful when new tanks or

at the container before it goes completely empty or having

cylinders are placed in service. Odor fade can occur in new

it refilled before it is completely empty.

tanks, or reinstalled old tanks, if they are filled and allowed

 

 

 

Page 4

13119-6-0107

Image 4
Contents Installation Instructions Table of Contents Important Safety Information Vent KIT InformationSafety Information for Users of LP-GAS Learn to recognize the odor of LP-gas. Your local LP-GasHave any question about the gas odor, call your LP-gas Measure under any conditionRequirements for Massachusetts Clear of ALL ObstructionsSpecifications IntroductionInstalling a New Main Gas Cock GAS SupplyLocating Gas Supply Recommended Gas Pipe DiameterChecking Manifold Pressure ClearancesClearances Installing Optional Side Outlets Installation InstructionsLocating Wall Opening Installation of Three-prong Grounding Plug Assembly Using Plastic Expansion AnchorsLocating Electric Supply Attaching Furnace to WallInstalling Vent Assembly Reassembly And Resealing Vent-Air Intake SystemFor Your Safety Read Before Lighting DVC-35T Standing Pilot Lighting InstructionsFor Your Safety Read Before Operating Pilot Flame Adjustment Pilot Flame CharacteristicsIP-Model Pilot Main Burner Flame Characteristics WiringThermostat Installation DVC-35TLadder Wiring DIAGRAM-IP Valve Service and Maintenance Suggestions DVC-35IPT Intermittent Pilot Sequence of Operation DVC-35IPT Intermittent Pilot System Troubleshooting Sequence HOW to Order Repair Parts Parts ListParts View Service Notes Service Notes 13119-6-0107

DVC-35T-1, DVC-35IPT-1 specifications

Empire Products has long been recognized for its commitment to delivering high-quality heating solutions, and two notable offerings are the DVC-35T-1 and DVC-35IPT-1 gas-burning direct vent fireplaces. These units are designed to provide both comfort and aesthetic appeal, making them excellent choices for any home environment.

The DVC-35T-1 model boasts a classic design, paired with modern efficiency. With a heat output of 35,000 BTUs, it effectively warms spaces up to 1,100 square feet, ensuring even heat distribution throughout the room. One of the standout features is its advanced venting system, which allows for horizontal or vertical venting options, making it versatile for different installation layouts. The DVC-35T-1 also comes equipped with an adjustable flame control, enabling users to customize the ambiance to their preference. Its glass viewing area enhances the overall aesthetic while providing a full view of the flames.

On the other hand, the DVC-35IPT-1 model features an innovative design that incorporates a premium fireplace insert. This unit is specifically engineered to fit into existing fireplaces, transforming traditional wood-burning setups into efficient gas-burning heating sources. Like its counterpart, the DVC-35IPT-1 offers a maximum heat output of 35,000 BTUs, providing substantial warmth tailored for spaces up to 1,100 square feet. It is equipped with a state-of-the-art electronic ignition system, which ensures reliable and easy starts every time. The unit also includes a decorative log set that adds to its realism and charm, allowing for a cozy, inviting atmosphere.

Both models prioritize efficiency, with an impressive thermal efficiency rating, which not only helps in reducing heating costs but also makes them environmentally friendly options. The incorporation of a sealed combustion system ensures that indoor air quality is maintained, as it draws outside air for combustion and expels exhaust gases outdoors.

In addition to their technical features, the DVC-35T-1 and DVC-35IPT-1 are designed with user convenience in mind. Remote control capabilities allow for effortless operation, while easy maintenance ensures that homeowners spend less time worrying about upkeep and more time enjoying their fireplaces.

Overall, the Empire Products DVC-35T-1 and DVC-35IPT-1 fireplaces represent a blend of efficiency, technology, and aesthetic appeal, making them ideal options for those looking to enhance their home environment with reliable and stylish heating solutions.