Lennox Hearth 32FS Door Rope Gasket, Door Gasket, Opening Side Panels, Motor Lubrication

Page 25

Door Rope Gasket

The condition of the rope gasket around the door and windows should be checked periodically and replaced or repaired if necessary. The door gasket does not need to be “tight” in all areas, since a small amount of leakage is not hazardous or detrimental to the performance of your stove.

Door Gasket

Figure 33 - Checking Door Gasket

Opening Side Panels

The hinged side panels are held closed with magnets. To open, grab the upper portion of the side panel (at front of stove) and pull each panel outward (see Figure 34). The side panels will hinge open from the back.

After maintenance is complete, close the side panels.

 

 

Right

Left

Side

 

Side

Panel

 

Panel

 

 

 

Figure 34 - Opening Side Panels

Motor Lubrication

The blowers are permanently lubricated by the manufacturer. Do not apply oil to any part of the blower, doing so may cause damage.

Blower Cleaning

Clean the air holes on the motors of both the exhaust and room air blowers annually. Remove the exhaust blower from the exhaust duct and clean out the internal fan blades as part of your fall start-up.

Rear Stove Compartment

The rear stove compartment should be cleaned periodically (a minimum of once a year). DISCONNECT ELECTRICAL CORD PRIOR TO CLEANING STOVE. Any household dust, pet hair or sawdust should be vacuumed or wiped out of the rear compartment of the stove, room air blower, and combustion blower (paying special attention to vacuuming out the intakes of both blowers). The electrical components should be wiped clean.

Glass Cleaning

DO NOT CLEAN THE GLASS WHEN THE STOVE IS HOT. To clean glass, use a mild non-abrasive cleaner when cool. Glass cleaners that are designed for stove glass is recommended. Creosote builds up on glass quickly when fire is burned at lowest settings. DO NOT use abrasive cleaners on glass. Periodically clean out the door air wash (a groove at the bottom of the door). This air wash directs air over the glass door to minimize soot buildup on the door.

Small Area Paint Touch-up

The stove body is painted with a quality high-temperature stove paint. Use only model TSPK-B Stove Paint, Catalog # 70K99. Do not touch-up your stove with any other paint.

Using one small piece of 320 grit sand paper and lightly sand the blem- ish so that the edges are “feathered” or smooth to the touch between the painted and bare surfaces. Do not let the sand paper gum up with paint, as this will cause scratches on the metal surface. If there are any scratches, use 600 grit sandpaper instead. Mask off surfaces you do not want painted. Paint lightly over the bare surface first as this will act as an undercoat. Then paint over a larger area in smooth even strokes to blend.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Free-Standing Pellet Stove Is installed Important Safety and Warniing InformationUsing this Manual Table of ContentsProduct is Subject to Change Without Notice Floor Protection Selecting a LocationNegative Pressure Warning Montage 32FS ClearancesMinimum Clearances To Combustibles Rear Wall or AlcoveSelect Your Installation Type Installation TipsHorizontal Installation Vertical & Horizontal InstallationManufactured Home Exhaust Vent Pipe Installation Guidelines Manufactured Home InstallationBolt Chassis Floor Installation Check List InstallationRemoving Appliance From Pallet Damper Location, Installation And Adjustment Venting Requirements = Clearance to inside corner *min /30cm Chimney Height Requirements Site Built Residential Home Chimney Height Requirements Manufactured HomesInstallation Chart Determining Size Of Pipe To InstallSample Installation Chart Installing Montage 32FS Standard Horizontal Vent InstallationBack Stove Quick51 mm Minimum Min WallHearth Pad / Floor Protection Min Preferred Installation Vertical Vent Through the RoofStart Care and OperationSimple Operating Instructions Control Board Operation Starting Your Pellet Stove Pre-lighting InstructionsGeneral Operating Considerations Manual and Automatic OperationAutomatic Safety Features Damper Adjustment GuidelineTurning Off Your Stove Damper OperationCleaning Routine MaintenanceFuel Fuel Feed RatesHeat Exchange Tubes Cleaning Behind Tube ScraperUnplug Stove UltraGrate UltraGrate Burn GrateAsh Slide Plate Ash PanBlower Cleaning After maintenance is complete, close the side panelsGlass Cleaning Door Rope GasketProduct Reference Information Specifications Montage 32FSFlue Size Mm Rear Floor Protection RequirementsANY Reason Component DefinitionsQualified Technicians Only TroubleshootingClosed position Thermal switch and control board There is no power to the stoveReplace the low limit thermal switch Heat exchanger area Vacuum cleaner is leakingGaskets Item # Cat. No Description1710 Replacement Parts List Montage 32FSReplacement Parts Diagrams Item # Cat. No Model Description Optional Accessories Optional AccessoriesAccessories Lennox Hearth Products Safety / listing labelReplacement parts WarrantyProduct reference information 775,196M REV. NC 06/2008

32FS specifications

The Lennox Hearth 32FS is an exceptional fireplace designed to enhance both the aesthetic and functional aspects of any home. With its innovative technologies and user-friendly features, this model stands out as a premier choice for those looking to introduce warmth and elegance into their living space.

One of the primary features of the Lennox Hearth 32FS is its impressive heating capacity. With a BTU output that provides efficient heating to large areas, this fireplace is perfect for open floor plans or vast living rooms. This capability ensures that the space remains cozy and inviting even in the coldest months.

The combustion technology integrated into the Lennox Hearth 32FS is noteworthy as well. Utilizing a clean-burning system, it maximizes heat output while minimizing emissions, making it an environmentally-friendly option. The glass door design enhances air regulation and combustion efficiency, ensuring that homeowners get the most out of each burning cycle.

Another characteristic that sets the 32FS apart is its aesthetic appeal. The fireplace features a sleek and modern design, allowing it to blend seamlessly into various home decors, from traditional to contemporary. Customizable options, including different front designs and surround materials, allow homeowners to choose a look that aligns with their personal style.

Additionally, the Lennox Hearth 32FS provides ease of use and control. The model comes equipped with an intuitive remote control system, allowing users to adjust settings without leaving their seat. Whether it’s adjusting the flame height or configuring the thermostat, the convenience provided by this technology is undeniable.

Durability and build quality are other prominent aspects of the Lennox Hearth 32FS. Constructed from high-quality materials, it is designed to withstand the test of time, ensuring consistent performance year after year. The fireplace’s design includes advanced insulation techniques, which not only enhances efficiency but also ensures safety during operation.

In summary, the Lennox Hearth 32FS is a sophisticated fireplace featuring advanced heating capabilities, clean combustion technology, and a stylish design that caters to varying tastes. Its user-friendly controls and durable construction make it a reliable choice for anyone looking to invest in an energy-efficient heating solution that adds charm and comfort to their home.
Top Page Image Contents