Trane TCONT802AS32DA installation instructions Application, When Installing this Product

Page 1

TCONT802AS32DA Touch Screen and TCONT803AS32DA Touch Screen with Dehumidification Control Comfort Controls

18-HD25D19-3

INSTALLATION INSTRUCTIONS

APPLICATION

The TCONT802AS32DA and TCONT803AS32DA Touch Screen Comfort Controls provide electronic control of 24 Vac heating and cooling systems. See Table 1 for a general description.

Table 1. TCONT802AS32DA and TCONT803AS32DA Comfort Control Description.

 

 

 

 

 

Power Method

Changeover

System Selection

Fan Selection

Comments

 

 

 

 

 

 

 

 

 

 

24 Vac common

Automatic or

Heat-Off-Cool-

On-Auto-Circ

System and Fan selection

wire

manual selectable

Auto (Em. Heat

 

vary based on system type

 

 

for heat pumps)

 

 

 

 

 

System and Fan selection

 

 

 

 

 

 

 

 

vary based on System type.

 

 

 

 

Humidity sensor to control

 

 

 

 

dehumidification.

 

 

 

 

 

MERCURY NOTICE

If this control is replacing a control that contains mercury in a sealed tube, do not place your old control in the trash. Dispose of properly.

Contact your local waste management authority for instructions regarding recycling and the proper disposal of the old control.

INSTALLATION

When Installing this Product...

1.Read these instructions carefully. Failure to follow the instructions can damage the product or cause a hazardous condition.

2.Installer must be a trained, experienced service technician.

3.After completing installation, use these instructions to check out the product operation.

Selecting Location

Install the comfort control about 5 ft. (1.5m) above the floor in an area with good air circulation at average temperature. See Fig. 1.

NO

 

YES

 

NO

NO

5 FEET

[1.5 METERS]

M19925

Fig. 1. Selecting comfort control location.

U.S. Pat. No. 6595430, D509151, and Other Patents Pending

69-1790-3

Image 1
Contents Application When Installing this ProductSelecting Location Disconnect power before wiring Installing WallplatePub. No -HD25D19-3 Heat Pump PM-A Variable Speed AIR Handler Heat Pump Variable M24202 Vac Common Power Recommended Powering the Comfort ControlBattery Power Optional Using the Comfort Control Adjusting Real-Time ClockSetting Calendar and Time Mounting the Comfort ControlOperation System and Fan SettingsLED Indication Requires 24 Vac Common Connection Installer Setup Installer Setup Menu Factory Setting Other Choices Cycles per 0240 Heat Stage 1 cycles Deadband 0310 Adaptive 0530 Adaptive Intelligent Conventional recovery Overshoot System Checkout Installer System TestOutdoor or Indoor Temperature Sensor Advanced FeaturesSpecial Heat Pump Features Dehumidification Droop ControlTroubleshooting Symptom Possible Cause Action Troubleshooting see TableRegistered Trademark