Petsafe PPA11-13128, PPA11-13141, PPA11-13135 Install Glass Sweep and Weather Stripping

NOTE: Inspect location of screw marks to make sure they will not be in contact with glass on either the sliding glass door or the Patio Panel when drilling. If needed, move the template over slightly and remark the screw holes.

4B

Patio Panel

4B Drill four 7/64” (2.5 mm) holes. DO NOT drill completely through the other side of the sliding glass door or Patio Panel.

4C	Patio
	Panel

4C Secure the latch and keeper with four

3/4” flat head sheet metal screws. DO NOT OVERTIGHTEN.

Helpful Tip: If overtightening results and you have stripped the connection, move the latch slightly up or down and re-drill mounting holes. Another option is to drill existing holes to a larger size and install plastic anchors. Plastic anchors can be purchased at any local hardware or home improvement store.

Step

5

Install Glass Sweep and Weather Stripping

5A	Patio door shown here slightly open
	Freedom™ Patio Panel Pet Door
	Install glass sweep here
	Install weather stripping here
	5A The glass sweep should be
	installed on the back edge of the
	sliding glass door to form a seal
	between the sliding glass door
	and the stationary glass door. The
	weather stripping should be

installed on the front edge of the sliding glass door to form a seal between the Freedom™ Patio Panel and the sliding glass door.

www.petsafe.net9