Trane PKG-PRC002-EN manual Integrated Self-Contained Systems, Integrated Comfort System ICS

Page 6

Features and Benefits

Integrated Self-Contained Systems

Integrated Comfort™ System (ICS)

Trane’s Integrated Comfort™ system (ICS) increases job control by combining IntelliPak® Signature Series self- contained units and aTracer® building management system. This integrated system provides total building comfort and control. Building owners and managers not only save energy when using ICS—they have the ability to automate their facilities and the convenience of a control system interface.

Simplifying The Comfort System Trane’s designers combined new technology and innovation to bring you more system capabilities and flexibility. Our Integrated Comfort™ system (ICS) with HVAC equipment is easy to use, install, commission, and service.

Everything you need to know about your self-contained VAV system is available usingTracer®,Trane’s family of building automation products.Tracer® is a software package that minimizes custom programming requirements and allows easy system setup and control using your personal computer. Operating data from all system components is readily available for evaluation.You can control, monitor, and service your facility—all from your personal computer.

The IntelliPak® self-contained unit, as part ofTrane ICS, provides powerful maintenance monitoring, control, and reporting capabilities.Tracer® places the self-contained unit in the appropriate operating mode for: system on/off, night setback, demand limiting, setpoint adjustment based on outside parameters and much more.You can monitor unit diagnostic conditions throughTracer such as: sensor failures, loss of supply airflow, and an inoperative refrigerant circuit.

IntelliPak® Signature Series self- contained monitoring points available using Tracer®

•Compressor on/off status

•Ventilation status

•Condenser water flow status

•Heat status

•Supply air pressure

•Supply air temperature

•Suction temperature of each circuit

•Entering economizer water temperature

•Zone temperature

•Entering condenser water temperature

•Supply air temperature reset signal

•Morning warmup sensor temperature

•Entering air temperature

Tracer control points for IntelliPak® Signature Series Self-Contained Units

•Cooling and heating setpoints

•VAV discharge air temperature setpoints

•Supply air pressure setpoint

•Cooling and heating enable/disable

•Air economizer enable/disable

•Airside economizer minimum position

•Unit priority shutdown

Commissioning, control, efficiency, and information…it simply all adds up to one reliable source…Trane.

6

PKG-PRC002-EN

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Commercial Self-Contained DecemberIntroduction Signature Series Self-Contained UnitsContents Features and Benefits Standard Features Optional FeaturesIntegrated Self-Contained Systems Integrated Comfort System ICSProven DesignThroughTesting and Research Trane 3-DScroll CompressorLow Torque Variation Supply Air Ductwork Application Considerations Self-ContainedReturn Air Ductwork Equipment Room Location and OrientationIsolation Recommendations Condenser Water PipingUnit Operating Limits Considerations ApplicationAir Cooled CondenserUnit Capacities Procedure Self-ContainedSelection Waterside Economizer CapacitySelection Example Design Conditions Unit SelectionDescription ProcedureModel Number Self-Contained Model Number DescriptionSelf-Contained Accessory Model Number Description Remote Air-Cooled Condenser Model Number Description General Data TonsTable GD-3. SCWF/SIWF Water-Cooled Self-Contained, 42-80Tons SCRF/SIRF Table GD-4. SCRF/SIRF Air-Cooled Self-ContainedGeneral Data CCRC/CIRCHeating Coil Table GD-7. Self-Contained Heating CoilDrops Data Chart PD-5. Airside Pressure DropPerformance DropsAirside Pressure Heating CoilsDischarge Plenum 20 to 38 Ton Unit 42 to 80 Ton UnitAirside Pressure Airside Economizer with Standard Damper Airside Economizer with Traq Damper Chart PD-21. Waterside Pressure Drop SCWF/SIWF 35 WatersidePressure Drop SCWF/SIWF Performance Water-Cooled Data Table PD-1. CFM Capacity Correction TableTable PD-2. SCWF/SIWF 20 Economizer Full Capacity 8,000 cfm Water-Cooled20 Ton Table PD-3. SCWF/SIWF 20 Economizer Low Capacity 8,000 cfmEntering WaterTemp Entering Air 75 F 85 F 95 F 22 Ton Table PD-5. SCWF/SIWF 22 Economizer Full Capacity 8,800 cfmTable PD-6. SCWF/SIWF 22 Economizer Low Capacity 8,800 cfm EnteringWaterTemp Entering Air 75 F 85 F 95 F 25 Ton Table PD-9. SCWF/SIWF 25 Economizer Low Capacity 10,000 cfmEntering Water Temp Entering Air 75 F 85 F 95 F 29 Ton Table PD-12. SCWF/SIWF 29 Economizer Low Capacity 11,600 cfm84.2 32 Ton Table PD-15. SCWF/SIWF 32 Economizer Low Capacity 12,800 cfm94.5 35 Ton Table PD-18. SCWF/SIWF 35 Economizer Low Capacity 14,000 cfm401 320 38 Ton Table PD-21. SCWF/SIWF 38 Economizer Low Capacity 15,200 cfm434 373 42 Ton Table PD-24. SCWF/SIWF 42 Economizer Low Capacity 16,800 cfm403 84.1 46 Ton Table PD-27. SCWF/SIWF 46 Economizer Low Capacity 18,400 cfm83.8 52 Ton Table PD-30. SCWF/SIWF 52 Economizer Low Capacity 20,800 cfm596 471 58 Ton Table PD-33. Scwfsiwf 58 Economizer Low Capacity 23,200 cfm663 571 65 Ton Table PD-36. SCWF/SIWF 65 Economizer Low Capacity 26,000 cfmEntering Water Temp Entering Air 72 Ton Table PD-39. SCWF/SIWF 72 Economizer Low Capacity 28,000 cfm83.7 80 Ton Table PD-42. SCWF/SIWF 80 Economizer Low Capacity 29,800 cfm891 761 Air-Cooled Table PD-45. SCRF/SIRF 25 Gross Cooling Capacity 11,600 cfm Table PD-46. SCRF/SIRF 29 Gross Cooling Capacity 12,800 cfm 30 Ton Table PD-47. SCRF/SIRF 30 Gross Cooling Capacity 14,000 cfmTable PD-48. SCRF/SIRF 35 Gross Cooling Capacity 15,200 cfm 40 Ton Table PD-49. SCRF/SIRF 40 Gross Cooling Capacity 18,400 cfm50 Ton Table PD-50. SCRF/SIRF 50 Gross Cooling Capacity 23,200 cfmPerformance Air-Cooled Data60-TonTable PD-51. SCRF/SIRF 60 Gross Cooling Capacity 29,800 cfm Table PD-52. HotWater Heating Capacity Self-ContainedHeating Coils Table PD-53. Steam Heating CapacityControls Available Input and Output PointsHuman Interface Panel HI Standard IntelliPak Unit Control FeaturesIntelliPak Unit Features Main menus of the human interface panels areSequence Controls OperationControl Sequences Operation Gbas Binary Outputs Generic Building Automation System Module Gbas OptionGbas Analog Inputs Demand Limiting Binary InputWater Purge Airside OptionsAir-Cooled Condensers Inlet GuideVane ControlHeating Electric Occupied ZoneTemperature ControlUnoccupied ZoneTemperature Control Cooling and Heating Heating Hot Water or SteamSupply Air Temperature Control Unit Sequence Operation Supply Air Setpoint ResetSupply Air Tempering Hot Water and Steam Units Only Standard On All Units Zone SensorControls Options Model Number Digit 6 = A, BAYSENS017Thermometer to indicate temperature in the zone Setpoint thumbwheel for local setpoint adjustment Selection Procedures Electrical DataElectrical Data SCWF/SCRF Table ED-6. Single Stage Electric Heat Electrical DataTable ED-7. CCRC/CIRC Condenser Electrical Data Dimensions Self-Contained Weights Tons Ton Self-ContainedDimensions Self-Contained Weights 40-80 Ton Discharge Dimensions Metric mm Detail B Discharge DimensionsDischarge Dimensions English inches Detail a Electrical ConnectionsDimensions Air-Cooled Weights Condenser Ccrc Unit DimensionsRefrigerant and Electrical Connections DimensionsWeights Front View Looking at Control PanelHot Water Coil Steam CoilPlenum Dimensions Metric mm DimensionsPlenum Dimensions English inches Flexible Horizontal Discharge PlenumAirside EconomizerAirside Economizer Airside Economizer Dimensions English inches Airside Economizer Dimensions Metric mmZone Sensors Field-InstalledAdjustment Dual Setpoint, Manual/AutomaticZone Temperature Sensor Only Function LightsProgrammable Night-Setback Sensor Clearances ServiceService/Code Clearance Requirements Self-Contained ModelsTop View CCRC/CIRC 20 Top View CCRC/CIRC 35Top View CCRC/CIRC 50 Table W-2. Unit Weights CCRC/CIRC Dimensions WeightsTable W-1. Unit Weights SCWF/SCRF/SIWF/SIRF Table W-3. Variable Frequency Drive WeightsMechanical Specifications Self-Contained Signature Series Self Contained UnitsMechanical Air-CooledSpecifications Condenser Supply Air Temperature Control with Inlet GuideVanes Mechanical Specifications OptionsAir Volume/Temperature Control Zone Temperature Control Self-Contained OptionsAirside Economizer Interface Comparative Enthalpy ControlStandard Two-Position Damper Interface Airside Economizer Interface with Comparative EnthalpyLow Entering Air Temperature Protection Device Water Flow SwitchService Valves Non-fused Disconnect SwitchCupro-Nickel Condenser Protective Coating CabinetCoils Stainless Steel Drain PanLiterature Order Number

PKG-PRC002-EN specifications

The Trane PKG-PRC002-EN is a groundbreaking packaged rooftop unit designed to meet the diverse needs of commercial and industrial spaces. This model showcases Trane’s commitment to innovation, energy efficiency, and reliability, making it a preferred choice for HVAC professionals and building owners alike.

One of the main features of the PKG-PRC002-EN is its high-efficiency design. This unit leverages advanced technologies to minimize energy consumption while ensuring optimal cooling and heating performance. Its efficient compressor, coupled with enhanced heat exchangers, significantly reduces operating costs and energy bills, aligning with today’s sustainability goals.

The PKG-PRC002-EN features a robust and durable construction, which translates to enhanced longevity and reduced maintenance requirements. Designed for ease of installation, the unit is compact and lightweight, facilitating seamless retrofitting and integration into existing systems. Furthermore, its accessible service panels allow for straightforward maintenance and repairs, thus minimizing downtime and service disruptions.

Equipped with Trane's advanced control technology, the PKG-PRC002-EN offers precise temperature management, ensuring consistent comfort across different zones within a building. The intuitive controls enable users to program schedules and adjust settings based on their specific needs, enhancing comfort while maximizing efficiency.

The model also incorporates advanced filtration options, improving indoor air quality by effectively reducing pollutants and allergens. This focus on health and safety is essential, especially in commercial settings where air quality can significantly impact occupant well-being and productivity.

Another notable characteristic of the PKG-PRC002-EN is its low noise levels during operation, which is essential for maintaining a conducive indoor environment in workplaces, retail spaces, or educational institutions. The unit's design minimizes sound transmission, creating a more pleasant atmosphere for occupants.

In summary, the Trane PKG-PRC002-EN is a highly efficient, reliable, and user-friendly rooftop unit that combines advanced technology with robust construction. Its energy-saving features, superior air quality options, and focus on quiet performance make it an excellent choice for modern commercial HVAC applications, ultimately contributing to sustainable building practices and enhanced occupant comfort.
Top Page Image Contents