Honeywell HHT-080 Electronic Filter Clean Reminder, Oscillation Feature Model HHT-100 Series

ELECTRONIC FILTER CLEAN REMINDER

This model air purifier has an electronic filter check to remind you when to check and clean the HEPA- Type filters based on the air cleaner’s hours of use.

Fig. 5a	Will illuminate	Fig. 5b
When the HEPA-Type filters need to be cleaned, the light	when it is
will remain on until it is RESET. You may unplug the air	time to clean
	HEPA filters
cleaner without interrupting the filter check.

A red LED light will illuminate when it is time to clean the
filter.
You should periodically check the filter. Depending on
operating conditions, the filters should be cleaned every 6
months to a year.
To RESET the Electronic Filter Check:	HHT-080 Series	HHT-100 Series

When the filter monitor light remains on, it is time to check/clean the HEPA-Type filters and reset the filter monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED filter check light and hold for approximately 5 seconds until the light turns off (Fig 5a & 5b). Depending upon your individual usage (environment and hours used), you may need to check and clean the filters more or less frequently. If the HEPA-Type filters are cleaned before the filter monitor light turns on, the filter monitor should be reset at the same time.

These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon the concentration of contaminates going through the system. High concentrations of contaminates such as dust, pet dander and smoking will reduce the useful performance of the filter.

NOTE: The HEPA-Type filters are not washable.

OSCILLATION FEATURE (MODEL HHT-100 SERIES)

To help circulate fresher, cleaner air through the room, this unit has an oscillation feature.

•To turn Oscillation on, simply press the Oscillation button ( ) (Fig. 6).

•To turn Oscillation Off, press the button again.

Fig. 6

CLEANINGMAINTAININGTHEYOURHEPAS-TYPAGE FILTERS1WASHABLE PARTICLE PRE-FILTER

The Honeywell models HHT-080 Series and HHT-100 Series are equipped with permanent HEPA-Type filters which never need replacement with normal use.

To Clean Your HEPA-Type Filter:

•DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE HEPA-TYPE FILTER.

•To vacuum-clean the filter, hold the filter and run a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up the dirt and particles (Fig. 7). Repeat along the entire surface of the HEPA-Type filter.

•Note the filter may still be discolored even after cleaning it. This is acceptable and will not affect performance.

Fig. 7

•After vacuuming the filter, place it back into the air purifier housing and snap filter grille into place. If you have difficulty cleaning the filter, please visit us at www.kaz.com or call us at 1-800-332-1110.