Honeywell K9696V2 installation instructions Tables

Multi-Media Unit: Installation Instructions

!30	To upgrade a Multi-Media unit’s software, onsite	2–17
!31 Road map for using Multi software to obtain video		3–1
!32 To install Multi software		3–2
!33 To continue installing a Multi-Media unit ...		3–3
!34 To create an empty Multi db		3–4
!35 To name a site		3–5
!36 To make a record of a dial-up connection		3–6
!37 To make a record of a network connection		3–8
!38 To run a maintenance session on a Rapid Eye site		3–10
!39	To indicate the time zone of a Multi-Media unit	3–12
!40	To respond to a notification of conflicting time zones	3–13
!41	To set a unit’s clock automatically, using SNTP	3–13
!42	To set a unit’s clock manually, using a PC’s	3–14
!43 To configure a Rapid Eye site’s camera(s)		3–16
!44 To obtain video from a “live video session”		3–16
!45 To send and receive audio offsite		4–3
!46 To monitor and record		4–3
!47 To enable “talking to” a site		4–3
!48 To enable audio for use onsite, by LocalView		4–4
!49 To disable audio for LocalView		4–4
!50 To secure the unit		5–1
!51 To detach the sub-panel		5–2
!52 To connect an alarm sensor		5–6
!53 To configure inputs		5–6
!54 To set the FAULT RELAY to trigger		5–9

7.2Tables

Table 1 contents of Rapid Eye’s hardware kit, WAMULTI5HWP4		2–2
Table 2 contents of Rapid Eye’s software kit, WAMULTI5SWP4		2–2
Table 3 Panel connectors		2–3
Table 4	Time needed for a Multi-Media unit recovery	2–6
Table 5	Restriction for LocalView cycle times when setting low recording rates	2–9
Table 6	Commands for launching HyperTerminal	2–13
Table 7	Settings for HyperTerminal communications session	2–13

7–2