Honeywell 800-06894 manual Bypassing Protection Zones, Bypassing Individual Zones, Bypassing zones

SECURING THE PREMISES

Bypassing Protection Zones

Bypassing Individual Zones

The Bypass feature can be used when you want to intentionally arm your system with one or more zones unprotected. Bypassed zones are unprotected and will not cause an alarm when violated while your system is armed. All bypasses are removed when an Off sequence is performed. Bypasses are also removed if the arming procedure that follows the bypass command is not successful. The system will not allow panic, fire or CO zones to be

bypassed.

Bypassing zones

Ready To Arm

		Zones	System
Arm Away	Arm Stay	Message	Phone
Delay	10:18 AM June 8, 2010		More
			5000-100-006-V0
	Not Ready To Arm - Fault
2. Front
Door	FAULT
Bypass All	Clear	Bypass	Select
Faulted	Bypasses		Fault
			5000-100-141-V0

1.With the system in the disarmed state, select the “Zones” icon. The system displays the Zones/Bypass screen.

2.Select the zone(s) that you wish to bypass and then select “Bypass” OR if programmed, the “Bypass All Faulted” button allows you to bypass all faulted zones (excluding Panic, Fire or CO zones). The system displays a keypad.

Not Ready to Arm - Fault
Bypass Selected Zones	1	2	3
Enter Code:	4	5	6
	7	8	9
Cancel	Clear	0
			5000-100-067-V0

3.Enter a valid Code. The system returns to the Bypass screen and the zone(s) that are bypassed will be displayed.

4.Select the 2 icon to return to the home screen.

5.Arm the system normally. See ARMING THE SYSTEM section for procedure

– 27 –