Bosch Appliances APC-AMC2-4WUS, APC-AMC2-4WCF installation manual Demounting

Page 23

AMC2 4W

Installing en 23

5.2Demounting

NOTE!

i To remove the AMC2 4W from a mounting rail, first, remove all pluggable screw connectors.

Push down the AMC2 4W until it snaps out of the mounting rail. Pull the lower end of the AMC2 4W from the mounting rail.

Fig. 5.2 Demounting the AMC2 4W from a mounting rail

Bosch Security Systems

Installation manual

F.01U.024.965 V.4 2006.09

Image 23

Contents AMC2 4W Page Remarks Table of Contents Index OperatingAppendix AMC2 4W Internet Explanation of Used SymbolsPlease read carefully Important Safety Notes Safety InstructionsSafety Instructions en FCC & Ices Information Read instructions Safety PrecautionsHealth and Safety Unpacking Description of the AMC2 4W IntroductionAMC2 4W in a four door safety lock Upper circuit board with display top side Equipment ConfigurationOverview Interfaces Jumper at the bottom side Performance Characteristics System overview System Overview RTC Technical DataAMC 5VA Mounting InstallingDemounting Opening the AMC2 4W Case Grounding and Shielding Conductor data for connection to power supplyCabling Location of ground jumper RS-485 host interface Grounding and Shielding the Host InterfaceAMC2 4W Grounding and Shielding the Extension Interface Connecting Power SupplyLocation of the power supply connector RS-485 Host Interface AMC2 4W RS-485 host interface 1 RS-485 Two Wire Connection10 Settings for RS-485 two wire connections 2 RS-485 Four Wire Connection12 Settings for RS-485 four wire connection DIL Switch Address SelectorAMC2 4W RS-232 Host Interface Address DIL SwitchesMode DIL Switches 14 Location of the RS-232 serial interface Ethernet InterfaceIpconfig /flushdns Wiegand Interface for Card Readers RS-485 Extension Module Bus17 Location of the Wiegand interfaces for external devices 18 Location of the relay output connectors Connecting Relay Outputs19 Wet mode and dry mode of the AMC2 4W relay outputs Keep in mind the following specificationsRisk of Damage 20 Schema of the using of the recovery diode21 Location of relay output jumpers bottom side Connecting Analog Input DevicesComplete connection diagram of the analog input devices is Tamper Protection AMC2 4W Status Display of the AMC2 4W OperatingDig Push Display Example DescriptionDig. IO Resetting the Software Configuring the Ethernet InterfaceResetting the AMC2 4W Restarting the AMC2 4W with the provided screw driver Resetting the Network ConfigurationsAMC2 4W Appendix Connecting DiagramsConnecting diagram of the RS-232 serial interface AMC2 4W Power supply Twisted pair connection Transmitter Receiver I L O P IndexPage Bosch Security Systems