Bosch Appliances APC-AMC2-4WUS, APC-AMC2-4WCF Connecting Analog Input Devices

Page 44

44 en Installing

AMC2 4W

Fig. 5.21 Location of relay output jumpers (bottom side)

5.12Connecting Analog Input Devices

The AMC2 4W has eight analog inputs, for example, for poten- tial free lock mechanisms or to detect if a lock is closed or open. The inputs will be connected to the 2-pin pluggable screw connectors: S3, S4, S8, S9, S15, S16, S20, and S21 - see Figure 7.5.

F.01U.024.965 V.4 2006.09

Installation manual

Bosch Security Systems

Image 44

Contents AMC2 4W Page Remarks Table of Contents Index OperatingAppendix AMC2 4W Internet Explanation of Used SymbolsPlease read carefully Safety Instructions Important Safety NotesSafety Instructions en FCC & Ices Information Read instructions Safety PrecautionsHealth and Safety Unpacking Introduction Description of the AMC2 4WAMC2 4W in a four door safety lock Equipment Configuration Upper circuit board with display top sideOverview Interfaces Jumper at the bottom side Performance Characteristics System Overview System overviewTechnical Data RTCAMC 5VA Installing MountingDemounting Opening the AMC2 4W Case Grounding and Shielding Conductor data for connection to power supplyCabling Grounding and Shielding the Host Interface Location of ground jumper RS-485 host interfaceAMC2 4W Connecting Power Supply Grounding and Shielding the Extension InterfaceLocation of the power supply connector RS-485 Host Interface AMC2 4W 1 RS-485 Two Wire Connection RS-485 host interface2 RS-485 Four Wire Connection 10 Settings for RS-485 two wire connectionsDIL Switch Address Selector 12 Settings for RS-485 four wire connectionAMC2 4W RS-232 Host Interface Address DIL SwitchesMode DIL Switches Ethernet Interface 14 Location of the RS-232 serial interfaceIpconfig /flushdns RS-485 Extension Module Bus Wiegand Interface for Card Readers17 Location of the Wiegand interfaces for external devices Connecting Relay Outputs 18 Location of the relay output connectorsKeep in mind the following specifications 19 Wet mode and dry mode of the AMC2 4W relay outputs20 Schema of the using of the recovery diode Risk of DamageConnecting Analog Input Devices 21 Location of relay output jumpers bottom sideComplete connection diagram of the analog input devices is Tamper Protection AMC2 4W Operating Status Display of the AMC2 4WDig Push Display Example DescriptionDig. IO Resetting the Software Configuring the Ethernet InterfaceResetting the AMC2 4W Resetting the Network Configurations Restarting the AMC2 4W with the provided screw driverAMC2 4W Connecting Diagrams AppendixConnecting diagram of the RS-232 serial interface AMC2 4W Power supply Twisted pair connection Transmitter Receiver Index I L O PPage Bosch Security Systems