Bosch Appliances APC-AMC2-4WUS RS-232 Host Interface, Address DIL Switches, Mode DIL Switches

Page 36

36 en InstallingAMC2 4W

Address			DIL Switches
		1	2		3	4
none		OFF	OFF		OFF	OFF
1		ON	OFF		OFF	OFF
2		OFF	ON		OFF	OFF
3		ON	ON		OFF	OFF
4		OFF	OFF		ON	OFF
5		ON	OFF		ON	OFF
6		OFF	ON		ON	OFF
7		ON	ON		ON	OFF
8		OFF	OFF		OFF	ON
Table 5.1	Setting the RS-485 address with the DIL switch

Mode		DIL Switches
Mode		5	6
		5	6
ON		SDEB	RS-232
OFF		BPA	RS-485
Table 5.2	Protocol and connection settings

5.7RS-232 Host Interface

The AMC2 4W offers an RS-232 serial interface to connect a host computer or serial modem.

CAUTION!

! Cable length between two RS-232 COM serial interfaces must not exceed 15 meters (45 ft).

F.01U.024.965 V.4 2006.09

Installation manual

Bosch Security Systems

Image 36

Contents AMC2 4W Page Remarks Table of Contents Operating AppendixIndex AMC2 4W Explanation of Used Symbols Please read carefullyInternet Safety Instructions Important Safety NotesSafety Instructions en FCC & Ices Information Safety Precautions Health and SafetyRead instructions Unpacking Introduction Description of the AMC2 4WAMC2 4W in a four door safety lock Equipment Configuration Upper circuit board with display top sideOverview Interfaces Jumper at the bottom side Performance Characteristics System Overview System overviewTechnical Data RTCAMC 5VA Installing MountingDemounting Opening the AMC2 4W Case Conductor data for connection to power supply CablingGrounding and Shielding Grounding and Shielding the Host Interface Location of ground jumper RS-485 host interfaceAMC2 4W Connecting Power Supply Grounding and Shielding the Extension InterfaceLocation of the power supply connector RS-485 Host Interface AMC2 4W 1 RS-485 Two Wire Connection RS-485 host interface 2 RS-485 Four Wire Connection 10 Settings for RS-485 two wire connectionsDIL Switch Address Selector 12 Settings for RS-485 four wire connectionAMC2 4W Address DIL Switches Mode DIL SwitchesRS-232 Host Interface Ethernet Interface 14 Location of the RS-232 serial interfaceIpconfig /flushdns RS-485 Extension Module Bus Wiegand Interface for Card Readers17 Location of the Wiegand interfaces for external devices Connecting Relay Outputs 18 Location of the relay output connectorsKeep in mind the following specifications 19 Wet mode and dry mode of the AMC2 4W relay outputs20 Schema of the using of the recovery diode Risk of DamageConnecting Analog Input Devices 21 Location of relay output jumpers bottom sideComplete connection diagram of the analog input devices is Tamper Protection AMC2 4W Operating Status Display of the AMC2 4WPush Display Example Description Dig. IODig Configuring the Ethernet Interface Resetting the AMC2 4WResetting the Software Resetting the Network Configurations Restarting the AMC2 4W with the provided screw driverAMC2 4W Connecting Diagrams AppendixConnecting diagram of the RS-232 serial interface AMC2 4W Power supply Twisted pair connection Transmitter Receiver Index I L O PPage Bosch Security Systems