Toshiba GN-1010 DIP Switches, DIP Switch Default Setting Factory Setting, Function of DIP Switch

DIP Switches

The DIP switches are used to make device settings.

— DIP Switch Default Setting (Factory Setting)

*Default Setting: 1to 3=OFF / 4=ON

—Function of DIP Switch

No.	ON	OFF	Description
1	INIT	< - >	Used to initialize the GN-1010.
			1. Turn the power of the GN-1010 ON.
			2. LED indicators (POWER, WLNK, WRX) begin to
			flash.
			3. While they are flashing (approx. 3 seconds), turn
			the DIP switch 1 OFF.
			• Before restarting or turning the power off, wait until
			the LED indicators (POWER, WLNK, WRX) stop
			flashing and the GN-1010 returns to the status prior
			to initializing.
2	-	-	This switch is always at “OFF”.
3	-	-	This switch is not used.
4	<INFRA>	-	This switch is always at “ON”.
			• Used in the infrastructure (Wi-Fi mode).

•The default setting for this device gives priority to the utility software.

•The GN-1010 operates as a station in default.

When the device connection is completed, the GN-1010 can operate as a station. Launch the utility software, then set the same ESS ID as that of the access point. When the WEP function is used, the WEP key setting is also required.

14 GN-1010 User’s Manual — Overview