GN-1010 User’s Manual — Functions of the Utility Software 43
File Management
This function is used to obtain the version numbers of the devices connected to the net-
work and to upgrade the firmware or read/write the settings file for the device selected
on the "Access Point List".
If upgrading the firmware is attempted using the files other than specified, performance
will not be guaranteed. Ensure that you use only the specified file.
1. [Type]...............................Selects setting file.
Firmware/Configuration File/Firmware (Wireless Card)/
MAC Address Filter File/Protocol Filter File
2. [Directory Name]............. Selects file name or directory name.
3. [Get Version]....................Obtains the version information.
• This obtains the verison information from all the devices
connctected to the same network group, or from only the
designated device.
• To obtain data from a device which exists beyond the IP
router, always select the device first. In this case, the IP
parameter must be set correctly.
4. [Read] (*1).......................Reads the firmware and setting file, then saves them on
the hard disk.
5. [Write] (*1).......................Writes the firmware and setting file saved on the hard disk
to the selected device.
6. [Reboot]...........................Reboots the selected device.
7. [Exit]................................ Returns to the main menu.
8. [Browse].......................... Browses file name or directory name.
(*1): The file name contains the lower 3 bytes of MAC address of the selected device.
(Ex.) [00-80-4C-4D-20-5E] → [4D205E.TXT]
1
2
3456
7
8