Kenmore 153.33385 owner manual

Page 18

9.Remove flange nuts holding inner door in place with 3/8” nut driver, see Figure 19.

15.Remove the Phillips-head screw holding the pilot bracket to the burner head, see Figure 22.

FIGURE 19.

10.Loosen flare nut “T” holding thermocouple to bottom of gas valve with 3/8” open-end wrench and pull down to remove, see Figure 20.

11.Loosen flare nut “P” holding pilot line to bottom of gas valve with 7/16” open-end wrench and pull tube down to remove, see Figure 20.

12.Loosen flange nut “B” holding burner tube to bottom of gas valve with 3/4” open-end wrench and pull down to remove, see Figure 20.

FIGURE 22.

16.Remove the two Phillips-head screws holding the natural burner head to the burner tube assembly, see Figure 23.

17.Using 3/8” boxed-end wrench remove the natural gas burner orifice from the burner tube. Install burner orifice marked “LP” and tighten securely, see Figure 23.

18.Locate and install the propane burner head to the burner tube using the two Phillips-head screws, see Figure 23.

FIGURE 20.

13.Grasp burner tube and remove burner assembly through inner door opening.

14.To remove the natural gas pilot assembly, remove the Phillips- head screw holding the TCO bracket to the burner tube bracket, see Figure 21.

FIGURE 21.

FIGURE 23.

19.Push the natural gas pilot assembly grommet out of the inner door towards the combustion chamber.

20.To install the propane pilot assembly, put the igniter wire, thermocouple lead, and pilot tube through the inner door hole. Reinstall the Phillips-head screw securing the TCO bracket to the burner tube. Reinstall the Phillips-head screw securing the pilot assembly to the burner head bracket.

21.Push the grommet into the inner door hole making sure the door fits into the groove in the grommet.

22.Reinstall the burner assembly through the door opening being careful not to damage the door gasket on the studs. Position end of burner tube inside bracket as shown in Figure 24.

FIGURE 24.

18

Image 18
Contents Economizer GAS Water Heater Safe INSTALLATION, USE and Service Important DefinitionsGeneral Safety Table of Contents Product Specifications Preparing for the InstallationCustomer Responsibilities Materials and Basic Tools Needed Materials NeededRelief Install PERGET to Know Your Water Heater ALL Piping Materials to be Supplied by CustomersInstallation Instructions Removing the OLD Water HeaterTypical Installations Hotter Water can ScaldLocating the NEW Water Heater Facts to Consider about the LocationInsulation Blankets Installing the NEW Water Heater Securing Water Heater to Floor and Wall Water PipingValve and Pipe Insulation TEMPERATURE-PRESSURE Relief Valve Water Piping Pressure TestOr Property Damage Filling the Water Heater Draft Hood Installation VentingGAS Piping Sediment Traps Alternative Sediment Trap LocationPage Page Operating Instructions Installation Checklist Before Lighting the PilotTemperature Regulation SettingVenting System Inspection Service and AdjustmentBurner Cleaning Burner InspectionTEMPERATURE-PRESSURE Relief Valve Operation Anode ROD InspectionDraining Drain Valve Washer Replacement ServiceTroubleshooting Guide Start UP ConditionsOperational Conditions CondensationLeakage Checkpoints Troubleshooting Guidelines Burner Assembly Parts Order ListPage Warranty Service Year Limited Warranty on Water HeaterYear Exclusive Kenmore Labor Warranty Sears Installation Service