When you remove the end caps, a small metal washer on each end
may come off. DO NOT lose these two metal washers.
TO CLEAN BRUSH:
NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacu- um, the brush assembly must be cleaned every time the belt is changed.
The brush assembly must also be cleaned according to the following schedule:
Vacuum Use | Clean | Brush | |
|
| Assembly | |
HEAVY | - | every | week |
(used | daily) |
|
|
MODERATE - | every | month | |
(used |
|
| |
LIGHT | - | every | 2 months |
(used | 1 time/week) |
|
|
Remove any dirt or debris in the belt path area or in the brush roller area.
Exploded View - Brush
Assembly
End | Agitator Unit | End |
Cap |
| Cap |
,/Carefully remove
caps and remove any string or debris located on the brush endassem-
bly, brush sup- ports, washers or agitator shaft.
IMPORTANT
Replace the washers and the end caps° See the exploded view for correct assembly=
TO REPLACE BELT:
Make sure that the carpet/bare floor
selector is in the carpet position.
Loop the new belt on the motor shall
Belt
Floor Selector Shaft
Shaft
Belt
Groove
NOTE: See PARTS AND FEATURES for belt #.
Loop the end of the new belt on the brush assembly.
Align the square extension on each end
cap with the slots in the frame of the nozzle.
Nozzle -
Nozzle slot
Slot
NOTE: Care must be taken due to the belt tension during reassembly.
17