Before assembling vacuum, check the PACKING LIST on the cover of the separate Repair Parts List. Use this list to verify that you have received all the components of your new Kenmore vacuum°
•WARNING
Electrical Shock Hazard
Do not plug Into the electrical sup- ply until the assembly is complete. Failure to do so could result in
electrical shock or injury.
HANDLE ASSEMBLY
Before assembling your vacuum cleaner be sure you have all the parts shown.
Cord
Hooks
Hole
Opening for Handle
Screw
Hole
Back of
Vacuum
Cleaner
Carry Handle
Screw
Remove the screw located just below the carry handle on the back side of the vacuum,
Position the handle so the cord hooks are toward the back of the cleaner.
Insert the handle Into the opening at the top of the vacuum.
Align | the | screw |
| \ | ||
hole | in the handle | |||||
with the | screw | hole | ||||
| ||||||
in the | vacuum° |
|
| |||
Insert | the screw | so | Ill | |||
it passes | through |
| ||||
the back | of | the |
|
| ||
vacuum | into | the |
| |||
handle. |
|
|
|
| ||
Begin to tighten | Handle | |||||
the screw with your | Screw | |||||
fingers. It may be | Hole | |||||
necessary to |
|
|
adjust the handle slightly.
__ | Carry Handle |
/