Kenmore 116.3181 manual Motor Safety Filter Cleaning, Exhaust Filter Replacement

	MOTOR SAFETY FILTER CLEANING	l
_, WARNING	Remove the dust bag as outlined in the DUST
	BAG REPLACEMENT section,

Electrical Shock Hazard

Unplug power cord from electrical outlet, Do not operale the vacuum cleaner without the motor safely filler. Be sure the filter is dry and properly installed to

prevent motor failure and/or electrical shock,

If the filter_ located in the bottom of the dust bag chamber_ is dlrty_ remove it by pul]lng forward out from under the ribs,

Wash the foam filter in warm soapy water, rinse and dry thoroughly by squeezing the filter in your hand and letting it air dryf

iiiii iii iiii i

MOTOR SAFETY FILTER

Check motor safety

filter frequently and clean when

dirty°

Filler Cover

Molar Safety

Filler

DO NOT wash in the dishwasher.

DO NOT install damp,

Replace the foam filter by sliding it back into

place under the ribs in the dust bag chamber,

Replace the dust bag as outlined in the DUST

BAG REPLACEMENT section,

EXHAUST FILTER REPLACEMENT ]

The HEPA exhaust filter must be replaced

when dirty. It should be replaced

regularly depending on use conditions_

The filter CANNOT be washed as it will lose its dust trapping ability.

Note: See PARTS AND FEATURES for the exhaust filter number.

1o Remove exhaust filter

cover by

pressing the release tab on

the cover and

rotating out from vacuum

cleaner_

2, Remove the

filter cartridge from cover.

3.Place new filter cartridge into cover making sure that airflow arrow on side of cartridge points into cover_

Place foam seal of filter against the vacuum cleaner body°

Exhaust

Filter

Seal Against

Vacuum Cleaner

4.Replace the exhaust filter cover by placing bottom tabs in slots and rotating in until cover snaps into place,

1B