This vacuum cleaner is equipped with a variable power control which will allow you to select any cleaning power from tow to high.
Set to LOW suction power for delicate fabrics such as draperies. Set to MAX or full power for more conventional carpet or bare floor cleaning.
To set to MAX suction power, move the control knob fully to the right.
Release the handle by pressing down on the handle release pedal with your foot and pulling back and down on the handle with your hand.
Bare floor setting: Slide the carpet/bare floor selector all the way back and down toward the bottomof the nozzle until it locks into place.
In this position the brush assembly does not revolve. This setting should be used for cleaning hardwood and tile floors and when any attachments (tools) are used.
Carpet setting: Slide the selector all the way forward and up to the carpet position.
In this position the brush assembly will turn. When carpets are being cleaned the selec- tor should be in this position.
Attention: Refer to your carpet manufac- turers cleaning recommendations. Some more delicate carpets may require that they be vacuumed with the agitator turned off, to prevent carpet damage.
Low Suction
Power
Variable
Control
For deep cleaning set the power control to
MAX.
CAUTION
NOTE: For longer belt life, turn vacuum off before moving selector. Failure to do so can cause the belt to rub on the selector shaft and may result in the belt becoming hot and creating a burning rubber smell.
Floor Selector
To Bare Floor
Position
Position