Cisco Systems 4300E manual Patrol Sequence Window

Chapter 3 Configuring and Managing the IP Camera

Feature Setup Windows

Table 3-7	Event Notification Window Options (continued)
Option		Description
Password		Enter the primary FTP server login password.
Enable Passive Mode		Check this check box to enable the passive mode feature of the primary FTP
		server.
Secondary FTP Server		Identify an optional secondary FTP server to which snapshots or video clips
		are uploaded by choosing IP Address or Hostname from the drop-down list
		and entering the IP address or host name in the corresponding field.
Secondary FTP Port		Enter the port number that receives messages on the secondary FTP server.
		The default FTP port number is 21.
User Name		Enter the secondary FTP server login user name.
Password		Enter the secondary FTP server login password.
Enable Passive Mode		Check this check box to enable the passive mode feature of the secondary
		FTP server.
Upload Snapshot		Check this check box to upload a snapshot of the activity that triggered the
		event.
		This functionality is available only when the secondary video stream is
		enabled.
Upload Video Clip		Check this check box and enter the following values to upload a video clip
		of the activity that triggered the event:
		• Pre-CaptureLength—Enter the amount of video (in seconds) before
		the event to include in the video clip. The default pre-capture length is
		0 seconds (no pre-capture video).
		• Post-CaptureLength—Enter the amount of video (in seconds) after the
		event to include in the video clip. The default post-capture length is 5
		seconds.

Patrol Sequence Window

The Patrol Sequence window provides options for configuring a patrol sequence for the IP camera. A patrol sequence consists of up to eight steps, each of which causes the camera to move to a designated preset position and remain in the position for a designated time.

When you create a patrol sequence, you define the order of the steps. When the patrol sequence runs, the IP camera goes to the preset position that is defined by the first step, then moves through each preset position in the configured order. It stops at the preset position that is defined by the last step.

Before you can configure a patrol sequence, you must define preset positions as described in the “Presets controls” rows in Table 4-1. These rows also explain how to start and stop the execution of a patrol sequence.

To display the Patrol Sequence window, access the configuration windows as described in the “Performing the Initial Setup of the IP Camera” section on page 2-5, click Feature Setup, then click Patrol Sequence.

If you change any options in this window, you must click the Save Settings button to save the change. If you do not click this button, changes are not retained when you exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.

	Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide
3-16	OL-25230-02