Cisco Systems 2900, OL-24281-01 manual Routing the Cables in the Back Box

Chapter 1 Installation

Mounting

Warning An electrical short in the back box may occur if the metal BNC connector on the video coaxial cable is not completely covered by the protective boot.

Step 7 Perform one of the following options:

•View video using both analog and IP connections—Connect the video coaxial cable from the back box circuit board to the coaxial cable coming in from the outside. Make sure that the BNC connector is completely covered by the protective boot.

•View video using only the IP connection—Make sure that the BNC connector is completely covered by the protective boot and is out of the way of the back box door.

Step 8 Before closing the interconnect door, ensure that no wires are between the top of the heat sink standoff and the back box (see Figure 1-8).

Both the video coaxial cable and the Ethernet cable need to be routed carefully to ensure clearance for the heat sink standoff.

Figure 1-8 Routing the Cables in the Back Box

1

2

RJ-45 Connector 3 Video Coaxial Cable

Ethernet Cable

Step 9 Close the interconnect door and snap the tab lock into place.

Cisco Video Surveillance IP PTZ Dome Camera User Guide, Cisco 2900 Series IP Dome

OL-24281-01 1-7