New Buck Corporation FS 21 installation instructions Model FS NON-CATALYTIC Unit

Page 1

MODEL FS 21

NON-CATALYTIC UNIT

FEATURES

PREPARATIONSINSTALLATION

OPERATIONMAINTENANCESAFETY

SAFETY NOTICE

IF THIS HEATER IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY

RESULT. FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS. CONTACT THE AUTHORITY HAVING JURISDICTION (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE PREVENTION BUREAU, etc.) CONSULT BEFORE INSTALLATION TO

DETERMINE THE NEED TO OBTAIN A PERMIT. KEEP THESE INSTRUCTIONS FOR FUTURE USE.

TESTED AND LISTED BY:

ITS/WARNOCK HERSEY, MIDDLETON, WI

MANUFACTURED BY NEW BUCK CORPORATION 200 ETHAN ALLEN DRIVE

P.O. BOX 69

SPRUCE PINE, N.C. 28777

www.buckstove.com

Revised July 2010

Image 1
Contents Model FS NON-CATALYTIC Unit Page Table of Contents Read this First Important Instructions INSTALLATION, OPERATION, Maintenance Instructions Model FSIntroduction SectionChimney Preparing the Stove for InstallationFloor Protection Preparing the Room Heater Location Model HOW to Locate Chimney Exit and Install 15.5 Residential and Mobile Home Installation C D E F G HOW to Locate Chimney Exit and Install Chimney Reefer to MANUFACTURER’S Installation Instruction Tools for Installation OUT Side AIR InstallationFlashing Final Check Section Alcove Installation Clearances Floor Protection Alcove Installation Alcove Installation Clearances Final Check Page Building a Fire Section OperationSure to Turn Blower OFF Before Removing Ashes ASH Removal InstructionsPage Step Wire Diagram #10 16 X 1/2 HEX Head #6 32 X 1/2 Slot Head Screw Section Wood Heater Safety Problem Possible Cause Solution Section TroubleshootingProcedure Warranty Time PeriodsProducts Covered Other Rights Conditions and ExclusionsOwner Registration Card