Therma-Stor Products Group Ultra-Aire 100V owner manual Maintenance, Service

Page 17

FOR HVAC INSTALLER AND HOMEOWNER

6. Maintenance

6.1 Standard Air Filter

The Ultra-Aire is equipped with a pleated cloth air filter. This filter should be checked monthly. Operating the unit with a dirty filter will reduce dehumidifier capacity and efficiency and may cause the compressor to cycle off and on unnecessarily on the defrost control.

To access the air filter, remove a filter access panel from one end of the Ultra-Aire. To remove the filter access panel from the Ultra- Aire, pull the panel straight up about 1⁄2" until the bolt heads near the bottom of the panel are centered in the larger opening of the keyhole slots. Next rock the bottom of the access panel away from the Ultra-Aire and lift the access panel straight up to remove the tab on top of the panel from the slot in the top of the Ultra-Aire. The filter should be readily visible and can be removed by pulling it straight out of the Ultra-Aire.

The pleated cloth filter can generally be vacuumed clean several times before needing replacement. Replacement filters can be ordered from the factory or purchased locally if available. DO NOT operate the unit without the standard filter or with a less effective filter than the standard filter; the heat exchange coils inside the unit could become clogged and require disassembly to clean.

6.2 High Efficiency Air Filter

An optional high efficiency pleated microglass paper filter is available for the Ultra-Aire. This filter is rated as 90%-95% efficient by the ASHRAE Dust Spot test method 52-76. The high efficiency pleated microglass paper filter should be used in conjunction with the standard filter, and placed directly beneath the standard filter.

This filter is able to remove allergy causing particles from the airstream. The high efficiency filter has a much larger surface area than the standard filter, thus the standard filter may need to be cleaned or replaced several times before the high efficiency filter requires replacement. Be careful not to damage the fabric media when handling the high efficiency pleated paper filter. Do not attempt to clean the high efficiency pleated paper filter. It should be replaced when it becomes restrictive (See Figure 7).

6.3 Fan Oiling

The fan motor is factory lubricated for many years of normal operation, however, periodic oiling will extend motor bearing life. To oil, remove the plastic cap from the two oiling tubes extending from the unit above the nameplate. Locate the oil ports on the motor as indicated in Figure 6. Add 3 to 5 drops of SAE 20 nondetergent oil to each port every 6 months. DO NOT use thinner oil or penetrating oil; fan life can actually be decreased by such oil.

7. Service

CAUTION: Servicing the Ultra-Aire with its high pressure refrigerant system and high voltage circuitry presents a health hazard which could result in death, serious bodily injury, and/or property damage. Only qualified service people should service this unit.

7.1 Warranty

A warranty certificate has been enclosed with this unit; read it before any repair is initiated. If a warranty repair is required, call the factory first at 1-800-533-7533 for warranty claim authorization and technical assistance.

7.2 Technical Description

The Ultra-Aire uses a refrigeration system similar to an air conditioner's to remove heat and moisture from incoming air, and add heat to the air that is discharged (See Figure 3).

Hot, high pressure refrigerant gas is routed from the compressor to the condenser coil (See Figure 3). The refrigerant is cooled and condensed by giving up its heat to the air that is about to be discharged from the unit. The refrigerant liquid then passes through a filter/drier and capillary tubing which cause the refrigerant pressure and temperature to drop. It next enters the evaporator coil where it absorbs heat from the incoming air and evaporates. The evaporator operates in a flooded condition, which means that all the evaporator tubes contain liquid refrigerant during normal operation. A flooded evaporator should maintain constant pressure and temperature across the entire coil, from inlet to outlet.

The mixture of gas and liquid refrigerant enter the accumulator after leaving the evaporator coil. The accumulator prevents any liquid refrigerant from reaching the compressor. The compressor evacuates the cool refrigerant gas from the accumulator and compresses it to a high pressure and temperature to repeat the process.

7.3 Troubleshooting

No dehumidification, neither fan nor compressor run with fan switch and ventilation timer OFF.

1.Unit unplugged or no power to outlet.

2.Humidity control set too high or defective (Sec. 3.3 & 5.7A)

3.Loose connection in internal or control wiring.

4.Defective Compressor relay.

5.Defective control transformer.

17

Ultra-Aire 100V Installer’s & Owner’s Manual

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Fresh Air Ventilation DehumidificationAir Filtration Serial NoTable of Contents Safety Precautions Safety PrecautionsSpecifications For Hvac Installer onlyInstallation Intended Application for Ultra-Aire4C Ducting for Fresh Air Humidity/Fan Control Panel Quiet InstallationControls Humidity Control Adjustment Ventilation Timer and Humidity Control PanelFan/Filter Switch Ventilation TimerHigh Efficiency Air filter DEH 3000 Digital Control DEH 3000 Digital Control Installation Instructions 2A Install Instructions2B Wiring 2D Dehumidifier lockout/activation AC sensor 2C Auxiliary relay operationDehumidification Engage A/C during dehumidification2E Location 2F Testing3B Setting For Hvac Installer and Homeowner3C On/Off Setting 3D Setting Clock TimeOperation For Hvac Installer only and Homeowner3F Fan Setting and Operation 3H Intermittent or Programmed Ventilation 3J Default Settings 3I Temperature Cutout ProgrammingService MaintenanceCompressor/Capacitor Replacement Fan ReplacementRefrigerant Charging 6A Checking Compressor Motor Circuits6B Replacing a Burned Out Compressor Remote Controls6C Replacing a Compressor, Nonburn Out 7A Humidity ControlElectric Ventilation Damper 7B Programmable Ventilation TimerDefrost Thermostat ULTRA-AIR 100V Electrical Schematic ULTRA-AIRE 100V Pictorial Electrical Diagram QTY ULTRA-AIRE 100V Service Parts List28 30 33 29 30 33 36 ULTRA-AIRE 100V Optional Parts ListULTRA-AIRE 100V External Insulation KIT ULTRA-AIRE 100V Control Panel Installation ULTRA-AIRE 100V Dehumidifier Limited Warranty PO Box 8680 Madison, WI Phone 608-222-5301 Fax

Ultra-Aire 100V specifications

The Ultra-Aire 100V by Therma-Stor Products Group is a powerful and efficient ventilating dehumidifier designed to tackle excess moisture in residential spaces. Known for its compact design and advanced technology, the Ultra-Aire 100V is an ideal solution for basements, crawl spaces, and high humidity areas.

One of the main features of the Ultra-Aire 100V is its high extraction capacity. With the ability to remove up to 100 pints of moisture per day, it effectively manages humidity levels, helping to prevent mold growth, mildew, and structural damage. This unit is equipped with an energy-efficient compressor that ensures optimum performance while minimizing energy consumption, making it an environmentally friendly choice for homeowners.

In addition to its powerful dehumidification capabilities, the Ultra-Aire 100V incorporates innovative technologies for enhanced functionality. The unit is designed with a built-in digital humidity control system, allowing users to set their desired humidity level with precision. The humidity control automatically adjusts the unit's operation, ensuring consistent moisture levels throughout the home.

Another key characteristic of the Ultra-Aire 100V is its convenience in installation and operation. The unit can be ducted into existing HVAC systems or operated as a standalone unit, providing flexibility to fit various home configurations. Its compact size also makes it easy to install in tight spaces, such as crawl spaces and attics, without sacrificing performance.

For added convenience, the Ultra-Aire 100V features a user-friendly interface. The digital display provides clear visibility of the current humidity level and operational status, while the built-in timer allows for programming operational schedules. This means homeowners can set the dehumidifier to run during specific times, optimizing performance and energy usage.

Durability is another hallmark of the Ultra-Aire 100V. Constructed with high-quality materials, this unit is built to withstand the challenges of damp environments, ensuring long-lasting performance. Additionally, its advanced filtration system captures airborne particles, improving indoor air quality by removing allergens and dust.

In conclusion, the Therma-Stor Products Group Ultra-Aire 100V stands out as a reliable dehumidification solution. With its high extraction capacity, energy-efficient operation, user-friendly controls, and durable build, this dehumidifier is an excellent choice for homeowners seeking to maintain a healthy and comfortable indoor environment. Whether combating humidity in a basement or managing moisture in a crawl space, the Ultra-Aire 100V proves to be an indispensable tool for humidity control.
Top Page Image Contents