White Rodgers 1F97-71 manual Programming

Page 17

•AUDIO PROMPTING — Each time you press a button, the thermostat will beep.

•BACKLIT DISPLAY — When you press any button on the thermostat, the display is lit for approximately eight seconds.

•SYSTEM INDICATOR LIGHT — The red light on the upper right part of the thermostat indi- cates system operation (see PARTS OF THE THERMOSTAT).

NOTE

On systems with Taco zone valves, the indicator light will flash during the heating cycle.

•COMPRESSOR SHORT CYCLE PROTEC- TION — To protect your compressor from potential damage due to rapid cycling, this thermostat has a built-in delay of 5 minutes between cooling cycles. The following may cause a time delay in COOL:

a) Return of power after a power outage.

b) Pressing SYSTEM to change operating

SWITCH

modes.

c)Pressing , creating a call for COOL too soon after a previous call.

•TOTAL KEYPAD LOCKOUT — When Group A option switch #1 is in the total keypad lockout position (ON), programs cannot be altered and all buttons are disabled.

NOTE

Programming should be completed and batteries should be installed before changing Group A option switches #1 or #2.

PROGRAMMING

17

Image 17

Contents 1F97-71 About Your New Thermostat Programming Your Your NEW ThermostatsSet Current Time and Day Your NEW THERMOSTAT’S Features Operating Your Thermostat Back of The Thermostat Body Parts of the ThermostatBack of Thermostat Body Display Digital Comfort SET System Thermostat Buttons 11 12 Operating Features To set the thermostat to Auto PressTWO Hour Temperature Override Auto Changeover Switch PositionsConvertibility Press Timefwd Selected setting until you press RUN toTime. To set cooling anticipation, press Clock Too long, press Backtime to decrease the cycleProgramming Programming Your Thermostat Total Keypad Lockout Switch PositionsPlanning for Your Needs Period Time Temp Heat a Heat B Heat C Heat D Cool a Cool B Cool C Cool D Press Clock once. The display will show Minutes only Set Current Time and DayHeating/Cooling Schedule Plan Sample After this happens, press Prgmview until you are at Select Heating and Cooling TemperaturesPress Prgmrun to resume program operation Until Heat is displayedPress View once. The display will show Press PrgmrunUntil PRG Program Heating/Cooling Times Heating TemperaturesPress Prgmview once. MON, the abbreviation for Tures, press Prgmrun Any other day see Using the HOLD/COPY ButtonBefore Reattaching the THERMO- Stat to the Subbase Program Cooling TemperaturesPress Complete until Copyhold has been pressed twice Using the HOLD/COPY ButtonBegin program operation Press Copyhold once. Copy will appear on Check Your ProgrammingTion mode you want HEAT, COOL, AUTO. Press Thermostat to subbase. Turn on power to System. Then pressPress Prgmview and Advday until you return to How can I permanently change a part of my program?This point, press RUN to start the normal Program function. See Programming Your ThermostatGramming Your Thermostat Why can’t I program the thermostat in the Auto mode?Programmed fan, press MostatAting Your Thermostat Immediately, pressThen press Thermostat beeps every few minutes. What does this mean? Display is flashing BATTERY. What does this mean?ING Your Thermostat See Operating Your Thermostat Back on, press Why is the system turning on and off so frequently seldom?Any time you wish to turn your system off Simply press Ming Your Thermostat Maintains programming, pressOFF is displayed, put the thermostat back on Wall, press Part No -5100A