Desa CGEFP33PR, CGEFP33NR, EFP33PR, EFP33NR, VTGF33NR, VTGF33PR

INSTALLATION

Installing Thermostatic Blower Accessory (Cont.)

INSTALLATION

Continued

10.Place control knob provided on plastic control shaft of speed control (see Figure 20).

11.Mount the speed control onto the front leg of the left floor support bracket using 2 screws provided (see Figure 20).

WARNING: Failure to connect all wires properly as indicated may cause electrical short circuit or personal injury. A qualified electrician should check that all connections are made properly.

12.Plug in blower power cord.

a.If your firebox is installed as a freestanding unit with an accessory mantel, determine whether the power cord will exit the left side or the right side of the firebox. Install one plastic bushing provided into the 1 1/2" hole in the floor sup- port on the exit side. Install the second bushing provided into the 1 1/2" hole in the outer casing through which the power cord will exit (see Figures 21 and 22). Route power cord through plastic bushings and plug the power cord into a prop- erly grounded three-prong wall receptacle near the firebox.

b.If your fireplace system installation is recessed and if an outlet is not installed in your fireplace, you must install the GA3555 Outlet kit with cover in your fireplace which will supply a convenient 3-prong grounded electrical outlet for your blower. Refer to the installation manual provided with the model GA3555 accessory for instructions on wir- ing the duplex outlet.

Note:A qualified installer must make all electrical connections.

Blower

Lower

Rear Wall

of Firebox

#8 Screws

Exhaust

Port

Top

Mounting

Tab

13.Check to make sure that the power cord and all wires are com- pletely clear of the blower wheel and that there are no other foreign objects in blower wheel.

CAUTION: Never touch the blower wheel while in operation.