Desa CGEFP33PR, CGEFP33NR, EFP33PR, EFP33NR, VTGF33NR, VTGF33PR BUILT-IN Fireplace Installation

INSTALLATION

Conventional Fireplace Installation (Cont.) Built-In Fireplace Installation

19

INSTALLATION

Continued

11.Carefully insert fireplace into cabinet mantel (see Figure 33). Be careful not to scratch or damage hearth base, cabinet man- tel, or any laminate trim on hearth base. Remove protective material from top of hearth base and from front of fireplace (if any). Note: You can secure fireplace to hearth or floor. Open lower louver. Locate screw holes in bottom of base. Tighten wood screws through these holes and into hearth or floor.

12.Check all gas connections for leaks. See Checking Gas Con- nections, pages 17 and 18.

Cabinet

Mantel

Figure 31 - Installing Cabinet Mantel

Nailing Flanges

BUILT-IN FIREPLACE INSTALLATION

Built-in installation of this fireplace involves installing fireplace into a framed-in enclosure. This makes the front of fireplace flush with wall. If installing a mantel above the fireplace, you must follow the clearances shown in Figure 37, page 20. Follow the instructions below to install the fireplace in this manner.

	Actual	Framing
Height	32 3/ "	33"
	8
Front Width	34 5/16"	35 1/2"
Depth	16 11/16"	17 3/4"

1.Frame in rough opening. Use dimensions shown in Figure 34 for the rough opening. If installing in a corner, use dimensions shown in Figure 35 for the rough opening. The height is 33" which is the same as the wall opening above.

2.Install and properly ground GA3555, three-prong 120 volt elec- trical outlet, in fireplace. Follow instructions included in kit (see Accessories, pages 42 and 43).

3.If not already completed, install gas piping to fireplace location. This installation includes an approved flexible gas line (if al- lowed by local codes) after the equipment shutoff valve. The flexible gas line must be the last item installed on the gas pip- ing. See Installing Gas Piping to Fireplace Location, page 15.

4.Carefully set fireplace in front of rough opening with back of fireplace inside wall opening.

5.Attach flexible gas line to gas supply. See Connecting Fire- place to Gas Supply, page 16.

6.Plug electrical cord(s) into electrical outlet installed in step 2.

7.Carefully insert fireplace into rough opening.

Figure 32 - Location of Nailing Flanges (EFP33PR Shown)

Figure 33 - Inserting Fireplace Into Cabinet Mantel (EFP33PR Shown)

17 3/4"

33"

35 1/2"

Figure 34 - Rough Opening for Installing in Wall

393/8"

27 7/8"

35 1/2" 55 5/8"

Figure 35 - Rough Opening for Installing in Corner

For morevisit www..com

108117-01G