24
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36D(S), BL36DH(S), BL42D(S), BL42DH(S) (Cont.) Installing Logs, Lava Rock and Glowing Embers
FIREPLACE INSTALLATION
Continued
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 43).
6.Install top brick panel by resting on the top of the rear panel. Hold the top brick panel in place and install left side brick panel by sliding it between the grate and the side of the fire- box, securing top panel (see Figure 44).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Follow instructions to install logs, lava rock, and ember material.
10.Close glass door and lock latches on top and bottom of door and replace screen. See Removing/Replacing Glass Door, steps 5 and 6, page 23.
11.Close top and bottom louvers.
Rear Brick Panel
Figure 43 - Installing Rear Brick Panel
Top Brick
Panel
Left Side
Brick Panel
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2 on page 23. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (base log) onto pin on left front side of grate as shown in Figure 45.
2.Rest left side of log #2 (front log) onto top of log #1. Place right side of log onto second pin located on right side of grate (see Figure 46).
3.Place log #3 (rear log) onto pins on rear of grate as shown in Figure 47.
1
Figure 45 - Installing Log No. 1
2
Figure 46 - Installing Log No. 2
3
Figure 44 - Installing Left Side and Top Brick Panels
Figure 47 - Installing Log No. 3
For
.
.com
