OPERATING FIREPLACE
Continued
LIGHTING
INSTRUCTIONS
WARNING:You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is installed before running fireplace.
NOTICE: During initial operation of new fireplace, burning logs will give off a
1. | STOP! Read the safety information, page |
| 19, column 2. |
2. | Make sure equipment shutoff valve is fully |
| open. |
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 21.
8.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4 through 8.
9.Slightly push in and turn control knob coun-
terclockwise 
to the ON position.
10.Wait one minute and switch selector switch to the ON position to light burner.
11.Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.
3. Set selector switch in OFF position. |
WARNING: Burner will come on automatically within one minute when the selector switch is in the ON position after the pilot is lit.
Control Knob
IH |
|
N | O |
O | F |
LO | F |
TOLI | |
| P |
Ignitor Button
AUTO
OFF
ON
4.Press in and turn control knob clockwise 
to the OFF position.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information, page 19, column 2. If you donʼt smell gas, go to the next step.
6.Press in and turn control knob counter-
clockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 38).
Note: You may be running this heater for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds or more. This will allow air to bleed from the gas system.
7.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
Flame Adjustment | Selector Switch | |
Knob | ||
|
Figure 38 - Control Knob and Ignitor
Button Location (Shown as Supplied, No
Control Options)
Pilot Burner | Ignitor | |
Electrode | ||
|
Figure 39 - Pilot (Propane/LP) | |
| Ignitor |
Pilot Burner | Electrode |
Figure 40 - Pilot (Natural)
20 | www.desatech.com |